Search:

Bingo!!!

I had this exact issue with an ineo 751 last year.

It was the BOOT CF card on the machine. It seemed like the card wasn't telling the NIC to boot correctly.
Try the BOOT CF from the working...

Utility/Counter - Administrator Settings - Register Administrator - Input Machine Address.
Change the Device Name. This will appear in the scan filename instead of SKMBT. It will have an S at the...

We are a DEVELOP dealer but we have many KM machines that we look after.
The ineo+ 452 drum and dev units work in the bizhub version without issues.

They are exactly the same.

It moves on each page yes.

We are going over today with a new MFP board, but will just change the memory 1st and see what happens.

Thanks guys

Been a while since I looked at a C352 but I think you need the HDD. PDF file type also.
Get your tech to check for the HDD in service mode, it needs to be enabled.
If it's not even fitted to the...

Brand new

Hi guys,

We have a C550 which is producing a 1" wide band on the page in cyan.
The band does not appear on the Y, M & K gradation test pages.
It runs top to bottom, not lead to trail and repeats...

If the drum claw solenoid and the claws themselves are clean and working, adjust the transfer/sep. Worked for me on dozens of 750/751's

Hi

I need £1,000,000.

Thanks

Did you read the previous posts? It does work without problems.

Dealer or end user?

Yes, based in Newcastle.

Wow that's daylight robbery.

My customer has gone through 20-30 bottles at least with no negatives to speak of.

I have a customer running the Ikon toner in a C6500 with no issues at all. £23 (Ikon) a bottle versus £40 (KM) a bottle is a no brainer.

You can use the ES1000 within CW5 to scan the proof Green they gave you, you can use the data to setup a profile.
Works a treat

I've got both the Konica and Develop versions out in the field. I have 1 customer that has had 5 751's and as long as you set them up with the countermeasure SW and only use genuine toner & parts,...

I've noticed within system 2 on the 501 a button called "OEM" which has a on or off setting. Don't know what that does as there is no description in the manual.

Fair enough. You need to enter service mode, system 2, dip SW, change the correct switch to show the OEM screen and print engine in the config page.

Why would you want to If it's an Oce machine?

Check that the ADU drive gear is connecting with the drive motor when the ADU is closed. It's on the right hand side at the back of the ADU, a white plastic thing with notches cut out. I've had it...

Looking at the messages, I'd say various problem units are isolated.
In service mode, look at either system 1 or system 2 (I forget which).
You are looking for "Problem Unit Isolation" I think it's...

Fuser errors need the trouble reset procedure to clear it. Sitch off the main power switch, hold down the utility/counter button and switch the main power back on whilst holding it. On the touch...

You don't need any software, the 223 will scan in several methods without any software.

The best option for you is via SMB. The 223 needs to be connected to your PC via a network for this to work....