Do not print PDF documents directly from your browser. Download the PDF and open with a dedicated PDF reader.
Not sure what the issue is printing PDF's from chrome, Firefox ex. It slow or simply...
Type: Posts; User: allan
Do not print PDF documents directly from your browser. Download the PDF and open with a dedicated PDF reader.
Not sure what the issue is printing PDF's from chrome, Firefox ex. It slow or simply...
+1 on the scanner. The scanner must complete initialization but for some or other reason can not do so. Does the LED on the scanner light up at all?
Like mentioned doing the diagnostics could help...
Are you replacing the PCR rollers only?
Then there is the A3/ Ledger paper in the PC415/6 LCT...
Once had a customer claiming the fax is not receiving, so I sent a fax to the machine and it went thru no problem. Had to drive 200km to...
There was a spring tension issue that caused the waste box and transfer belt shutter that prevents spillage not to open all the way. That was on the A3 i series machines.
In that case removing both...
If you read through the entire thread then you will see that the problem was resolved. Long story short a tech used a blower on the IDS assy and damaged a stepper driver on the main board due to a...
I mean the SCDB connection to the control board to dis the scanner not just the ADF..
Same here. Seems to work fine. Been doing that if I don't have the right item with me.
Strange question but does the machine accept a print job in that 25% booted stage? Had it where the scanner caused the machine to hang there but it would accept print jobs so you should be able to...
The problem is that the toner is caking up, even if you replace the cleaning blade the toner will simply stick to the cleaning edge causing the toner to smear on the drum.
Seen that happen due to an unearthed vacuum cleaner. On a C1100 I had to replace the shutter motor driver on the main board also due to guys using an electric blower on that sensor assy.
That is...
On the 55 and 65 ppm machines removing the cleaning roller and brush at around 300K helps it to go well past yield.
That happens moving back to original toner if CET toner was used. Yes it was your toner. You can dump all the developer...
Silly question. Did you check trouble isolation?
SMB is more secure FTP IMHO is simply more robust.
Yea I am wrong black rust is lighter than red rust so yes oxidation will turn black rust into red rust. I can still be wrong. You will need a lot of heat to go from red to black. Could then just need...
I have early 750i's using what seems to be the v2 fusers with the red sleeves. Then I guess here in ZA we are only getting v2 fusers. I am lucky if they make 400K. We are rebuilding them to recover...
Is developer not rust already?
Can Fe3O4(black) turn to Fe2O3(red) I am no chemist but isn't that called reduction not oxidation?
Have you set this up on a bizhub before?
Like tsb mentioned I have also done the engine sw on the 8 series color machines sw 31 32 33 34 for YMCK. Please correct me if I got this wrong. Can't remember if I did that on a monochrome or not...
On the 8 series you can reset the toner level indicators back to full using engine switches.
Are those lines in the feed or cross feed direction?
Shizer. That is something I have never had before. You say it just keeps adding toner to an already full hopper. So its not adding from the hopper to the tank? Else you should get like a C-2558...
Is it only jamming on double sided or single sided as well?
Have you removed and inspected the switch back section?
If you open the side door and close the duplex/syncro section you can make...
Looks like it could be poor primary and or poor secondary transfer.
Print a single demo page and pull the belt out to see how much residual image is on the transfer belt.
Are you getting normal IDS...