I had a similar thing happen on an ir5065 with a T1 finisher. Turned out that it was simply out of staples. Replaced the staples and it was back up and going. Upgraded firmware and haven't had the...
Type: Posts; User: kfallsken
I had a similar thing happen on an ir5065 with a T1 finisher. Turned out that it was simply out of staples. Replaced the staples and it was back up and going. Upgraded firmware and haven't had the...
It could also be potential control. To test, set copier>option>body>po-cnt to "0". I had one on which the two pin connector on the potential control board was loose.
Try Ikon Office Solutions - 888.456.6457
Haven't tried it on this particular machine before, but when I get void areas in the dev roller, I've tried sliding the corner of a sheet of paper between the dev roller and doctor blade and rotating...
Have you tried your spare HDD. I've had more than a couple that would cause a machine to reboot, just not strictly on dupex.
I had an MP6001 doing the same thing. The customer, however, wasn't aware that the stapling was enabled while doing single sheets. I ran the job with the finisher door open. It looked like it was...
The original post stated full color and a subsequent post stated "every time I print full color" and the sample I was referring to was simply the sample image that was included in the original post....
Tec, you say "that's all", but that's the point. The problem is happening while user is doing a job. At some point the machine is power cycling and throwing the power-on jam. Also the jams...
He didnt say it was only one color, it was just the sample he used.
Whenever I'v seen prints like that, it turns out that the upper fuser roller has flat spots. You can probably hear it rattling as it prints. The ufr (FB6-3641) can be replaced by itself, but you...
0Axx codes are power-on jams. Sounds like the machine is power cycling during a job. Could be a faulty hard drive if power source is reliable.
MODEL-SZ "0" for AB
MODEL-SZ "1" for inch
Make sure that COPIER>OPTION>BODY>MODEL-SZ is set to "0".
Looks to me like the a bad pcr. Replace drum.
If you are still having 0110 jams, you should check the white nylon flapper arm on the back of the delivery assy (FB5-3394). This arm is keyed to the shaft, but over time, the flat part of the key...
This error pertains to the CIS that reads the second side of the original as it passes through. You need to remove the ADF access door and inner covers until you can see the small motor assy that...