Search:

Recall the process adjustment standard data and perform the gamma auto adjustment after insuring that the drum cartridges and charge coronas are properly seated

a. Power on the copier while...

920, just shy of 6 million, new dv unit, dv, sep corona. Getting crappy txer on 2nd side, have followed all the bulletins, suggestions, bad advice, good advice, etc. Anybody got any ideas? Copies...

When you install the finisher on this machine you're supposed to snip of a set of gray rollers on the switchback unit. Are those gray rollers still on the exit unit?

Here's what KM's solution database comes up with for banding on c451, hope it helps
Description
Dark bands from front-to-rear on copies and prints. May be approximately 1½ inches wide.
Solution...

Same thing happened to me once, went through all that clutch trouble to no avail, ended up being the one ways. Also look on the front of the tray where the catch is, the trays tend to crack right...

haha, great stories everyone, thanks for the perk up

I hate my job, I get physically ill in the mornings knowing what's in store for the day. I've been at it for 7 years, and make a good wage. The only happy techs I've ever met were the ones who didn't...

konica c6500

So I've had a similar problem with the 600 series (you think they would have fixed it with the 601 series) where the paper stops at the finisher entrance gate (gate with two flaps kicked up by a...

No! you would have to be crazy. Don't do it unless you want to replace all your c360 imaging units

adu clutches (simple, cheap fix), if its got old firmware you'll get a "replace fusing unit" message that will not go away until you update fw at about 250k, and the dreaded toner problems. I've done...

Sounds like a bad NVRAM to me, if you have another 600 you can pop one off of, try swapping it out. If you don't have a spare, you'll have to jump through hoops to get a new one (NVRAM contains bank...