Once new firmware has been installed, you will need to go into user tools, admin settings and then certificates. activate new certificate and follow the screen directions. reboot and AirPrint will...
Type: Posts; User: collme
Once new firmware has been installed, you will need to go into user tools, admin settings and then certificates. activate new certificate and follow the screen directions. reboot and AirPrint will...
Found the info, an M7 adapter kit is needed to attach the BU3050 to the SR3150. Salesman obviously not ordered up the full kit lol
Can any one confirm that if you have an MP2553 and you want to attach an SR3150 booklet finisher then you need a BU3070 bridge unit. I am trying to set this machine up and the entrance guide on the...
Maybe a silly question, are you using OEM toner as none OEM toner can cause poor fusing on certain colours. Also Agree on yellow pattern. It is a serial number identification pattern which is printed...
Put it in the back of a lorry and drive down the motorway, that will make the machine go faster :p
Have a great Birthday Paul.
remove pcu and look at the gears that is in the rear of the machine, there are 2 for drum and dev drive, getting quite common to see these stripped now. tell tale sign is by looking into the supply...
from goose guide
D059/D060/D061
SC 495
Check toner supply motor voltage/trigger @ IOB CN 320 B2 and B5
D059/D060/D061
copied straight from goose guide
B064/B065
S C 490 main fan abnormal
replace exhaust fan - M13
The everlasting fuser roller will be created, so where do the manufactures make their profit to sustain the company for future models. If everything lasted to long then companies would go bust and we...
The circles are w
here he has circled the faint copy issue and is not what the machine is printing lol
lol :p
lower gate pawl part no D3694664
normally if it is fuser then it would be repeating image of the page which this is not doing, also image is on the drum, are you sure when you were fitting the new drum some sticky tape did not stick...
you will go and buy 305s. no sympathy lol
thought it was ipu and control boards if we are on about the orval range lol. That was not Ricohs fault, just got a crap set of chips :D
snow did not stop me, was the idiots who clogged the roads up between me and home
:rolleyes: what faulty parts lol
your fave machine that Venus lol
all this x2 and Make sure you use OEM drum and toner or problem will reoccur
if the pages are not separated fully then it will try and feed more than 1 original through causing jams. even with the staple removed, the pages can still be stuck together so need checking before...
We did a trial of stripping the coating off with a scourer and wiping them down with glass cleaner, also we removed the cleaning roller and cleaned out lube bar area. It really does work and you can...
replace the 2 gears which contain the one way bearings between fuser drive and heat pipe. I have to replace at regular intervals as cleaning the one way bearings does not stop them slipping.
both boards, there is a tb out for this and cheap chips on the board are at fault. new boards will sort the problem as debs said. had this fault last week.
You say you have cleaned the one way bearings, every time I have this issue I have replaced all the one way bearings for the heat pipe and exit transport rollers, it only needs to slip a fraction to...