Thank's for the reply. Can you tell me how to reset the controller connectors and also, is M2 paddle (motor) to do with the developing unit? Sorry for being dim..., this machine is not my usual kit....
Type: Posts; User: scanrail
Thank's for the reply. Can you tell me how to reset the controller connectors and also, is M2 paddle (motor) to do with the developing unit? Sorry for being dim..., this machine is not my usual kit....
Hi,
Just trying to find out what this error message relates to on a Canon IR 2800 E000577-0000
Machine seems to warm up...upper fuer roller heats up but ask for a copy and the machine attempts...
Hi all,
I have a call to do regarding the above...utax 1125 asking to check toner cart every few copies. The machine has a cartridge in that has plenty toner in it...has anyone come accross this...
It sounds like the problem could be due to the surface of the copying paper/card could be going through a change after being fused once ( after single side has been completed), because of the...
Thank you for that information, I will give it a go.
Regards.
Does the same apply if you put 80 gsm through?
Hello all...
Having trouble networking a knonica 7020. Print board installed is an IP 421 but when going into key op mode and selecting printer, it doesn't allow an IP address to be input. There...
Fuser problem. The error code does require a reset. In either 25 mode or 36 mode (cant remember) scan up to sw 3 then once in 3 scan up through the numbers to the right making sure they all have a...
Hi Dallas,
Thanks very much for the information, I will give it a go on Tuesday, hopefully that will do the trick. As I mentioned in the original post, the machine will not at all allow me in any...
Hi all,
It has been covered in the past however, I cant seem to find a simple answer anywhere, hope someone can help me.
Just installed a Konica 7020 that already had a 421 print board...
Hi,
Error E 004 relates to the fuser section. Sorry I dont have reset but some of the NP Canon's had no reset for this as such. It could be just a case of rectifying the problem, ie cleaning the...
Hi,
Can anyone help? I have F26-3 and have tried to auto supply toner with new toner bottle inserted but the fault remains:mad:, your help will be much appreciated.:o
Thanks Travi,
I'm a long way form the above but appreciate the supply number, many thanks.
Hi Travi,
Thanks for that. I have come accross this before with other manufacturers but normally there is a reset rather than having to install new bits housing a resistor/fuse that blows when...
Hi,
Can anyone help with this?
Message on Oki printer 3200...replace transfer belt. Is there a reset or an easy way to get around the problem without replacing the transport belt?
Thanks.:)
Can anyone help? Looking for a Km 2550 drum/Utax 1125, I think they are one and the same.
Many thanks.
Hi,
Im hoping to hear from anyone that can point me in the right direction for a Utax 1125 drum or a Kyocera M 2550 drum...I think they are one and the same?
Many thanks.