Search:

Thank you, the part you suggest is correct

Hi

I'm trying to find the part number for the data cable (cable from the document processor to the printer's system board). The Printer has been pushed against a wall which has damaged it.

Any...

Thanks. I need to do a bit more investigating as unsure if anyone has had the main drive out

I have a Taskalfa 300ci which has ongoing issues but today i spotted something that i believe others have missed........heavy MCY contamination but not BK.......several ITU belts for its...

Same as JSC i've seen 2 of these that have done this. This was caused by the user putting the user guide in the paper tray the other side of the paper, which stops the tray lifting properly. On both...

Just found the technical bulletin regarding adding a shim. thanks for the views

I have a Taskalfa 300ci with error code C2700 color release motor, so my question is.....is there another fix other than replacing the transfer belt. I have already had the belt out but i can't see a...

After stripping the machine back down and checking the wiring loom, i finally found a screw behind the main hvps. Replaced the part and all's good.

Sorry U89 when printing magenta on any test it was very light and cyan was completely missing

U131 was ok i think it was 116 for all (i'll have to look for the printout) , U89 the color belt you can bearly see the magenta the other tests are fine

Thanks for the quick reply Blackcat, i have pretty much ruled out the first two, i think there's possibly a broken or disconnected wire somewhere but have been unable to find anything as yet even...

Thanks for the reply the part number is 3at07010. Managed to find the parts manual.

Hi i looked at a kmc3232e which someone has replaced the DR820 (the colour drive unit) because of a broken gear, but since then it will only print magenta very lightly and not cyan at all, black and...

Hi

I'm looking for the part number of the upper paper guide on a PF-70 if somebody could help.

Thanks in advance

I did sim u24 as soon as I realised the machine worked ok with the network cable unplugged, but that didn't cure the fault. The fault was the cable
Thanks again for all your replies

Thanks for the updates, the problem is related to the network. With the cable disconnected the printer works fine, replaced the cable and updated the firmware to latest level.

Hi i have a KM5050 with an error CF620, i've been lead to believe it is related to the main controller board. My question is as a result will this need replacing or can i get away with a firmware...

Ok. if you're getting toner on the back of the print (anywhere and i'm gathering there isn't a duplex option installed) that has to be caused be one of the following - dirty second transfer unit -...

Not gone back to this copier yet, but have latest firmware ready version 09.01.0010 (2010-04-15). Thanks for the quick replies & config details

Hi, I look at a lot of these & mostly for image quality. Have you removed the led printhead from the image drum and cleaned it with a cloth?i would also pull the charge grid out and carefully wipe...

Hi i have a customer with a TaskAlfa 300ci which randomly drop very small dots on the prints in black, cyan & magenta perhaps a handful or so per page. The copier has printed about 40k and was...