Search:

Yep, Subaro good stuff.. A little reading ( research) goes a long way.........Salud/Cheers.......

Heheheeee! I just found this thread while researching that 11.00.XX error.. It's funny as I started working on printers many moons ago... Mostly "Line Matrix, Dot Matrix" and when Lasers first...

Great! so if you found the solution let us in on it.. That way we can all learn... Thx..

There are 2 resets on this one...

1. Reset Roller Kit Counter

2. Clear Supply Usage History

Power printer on and press and hold the #2 & #6 Buttons for approximately 10 seconds..That will...

Go to "precision roller dot com" and or call them.. They will tell you if whole tray is available..

They do show the tray/cassette in parts breakdown but do not have part # for whole assy... They...

Was wondering if anyone has any info and this F245 error code on the Kyocera FS-4100DN printer.. It is not listed in service manual and very little info online.. Also Kyocera has or provides any...

You can buy these from Muratec directly...........Google them......

I know there is another way to put this printer in download mode to upgrade Firmware.. But I cannot remember power on sequence ( which button(s) to push) As I cannot get thru "standard mode" any...

First thing is to try what we call a 1/2 page test... Print a test then open a cover when u feel paper is under toner and going into fuser... ( Note: you may have to try this multiple times until...

Is the unit asking you to reset it???.. Only thing I know there is a a "reset maintenance" option...Along with a "transfer belt fail clear" option... But the last option is only to clear belt...

Nope, If you are sure it's the Jet Direct then u must replace it... Some of the older plotters are also "finicky" if you upgrade the Jet Direct so it's better to replace with same version......

It will never happen...Lol... Most of these problems happen when Refurb fusers are replaced... Unfortunately on these models as Wild Bill mentions it is always a good idea to replace with new...

If the printer boots with error then most times it is a stuck sensor flag or sensor being obstructed..

You can always call Lexmark.. They do provide support.. But it does sounds like the Controler board is failing...

I found this for you... Its from a different HP MFP model but normally errors are pretty uniformed..Hope it helps..

"An error occurred during a V.34 transmission when the local machine was ...

Question on this..What is the actual procedure on resetting maint. count.. Is there a boot up sequence because it's not in the admin menus...or is the fuser reset the same as the Maintenance reset.. ...

I encountered this one where I am not able to reset the maint count... I tried thru the service menu and also no luck... Was told that there was something about some of these needing to have a...

Thanks Prnt... I just left it alone and and recorded the s/n imprinted on the tag.. Just thought it may have been on another menu I did not know about.. That is a little too technical..lol..

I am wondering if anyone knows how to input the serial # after replacing the formatter board.. It is usually in the Service menu on most..This one does not have it..Thanks in advance...

Yes, usually on these printer you do it thru the HP toolbox...

I agree...If it comes up with error on power up then it has to be a stuck sensor flag or obstructed sensor...Anywhere along paper path...Good luk....

My compliments to staff and members...Good looking site...Hope to learn and contribute where I can...Cheers...