Search:

Hi, have F000 on TA 1800. Firmware can't be updated.
Will be thankful for any suggestions.

Have faced this problem with control PCB. However the issue was resolved later, changes have been made in control pcb in current model.

Hello,
Would like to know about the performance of TA Pro 15000c.
Thanks

Sending pic of part

Have around 300 of these printers working. The problem can be reduced by lubricating the pad under the belt after every 3 months aprox.
Further had the base of oil pad fabricated in aluminium. Using...

Has to be replaced as far as I know.

New firmware is available. Update on all existing mc.
The issue has been resolved.

Yes, just going through simulation. Could not find details in manual, hence the curiosity.

U978 in service mode in KM5050?can't find its use.Thanks in advance for any suggestions.

Three fuse on power supply ,F1,F2,F101. Further ensure YC103 is properly connected. Further check F2,F5 on control card.

This problem is rectified by replacing the control card. What is bothering is that it is occurring regularly. The ratio is almost 25%.replacing control pwb is costly.

Hi every one,
I am coming across code CF010 on quite a few numbers of Ecosys 2035dn. Have tried upgrading firmware, but of no use. Any suggestion shall be welcome.

Thanks Mr.TECKAT. We use 300 dpi. to make screens for printing.

How can I use IRC3100 to print at 300dpi? shall be thankful for any guidance.

It is not only canon,I have come across Xerox machines too where you type in a code and behold! a 25 cpm mc. evolves into a 40 cpm one. We are talking of fair practice & clients getting their bucks...

Canon sells 2200 as 3300 after some minor changes in programmes,nothing is done to actually enhance the performance of the copier. Is it fair and ethical?

THANKS.

IR1600 is not a scanner.

Turmeric has very good healing properties,will cure head injuries both internal & external.

Worked on MITA DC121,B4 size copier with moving platen,Heat fixing looked like a big advantage then.

Status report shows off (sim204) That is before the problem occured.

"Insert key counter" is displayed on the panel.The copier is not equipped with a key counter.I have tried initializing memory using sim 020,021,022. problem persists. please help.

COPIER>OPTION>BODY > MODEL-SZ. settings:0:AB,1:INCH,2:A,3:AB/INCH.(for different original sizes.)
COPIER>OPTION>BODY>SCANSLCT. 0:OFF, 1:ON(disable or enable original size detection for ADF)

This is what I was looking for.Thanks a lot.

Change the UI,or to make it short exchange the operating panels and try booting the copier.