Hi All,
Have to attend a call on Monday for H7-10 and having checked through previous post nothing specific for Polaris but for smaller B&W machine, I have seen a fix to be the HL PWB.(Heater Lamp...
Type: Posts; User: rayjeek
Hi All,
Have to attend a call on Monday for H7-10 and having checked through previous post nothing specific for Polaris but for smaller B&W machine, I have seen a fix to be the HL PWB.(Heater Lamp...
Update.. The CCD replaced to resolve problem.
Thanks.
No work done on the mirror but as you mentioned will have a look at the mirrors
Thanks Zootech. Will check it
Hi Phil,
All SM parts are ok. The problem is with the scanner as prints are fine. Also with double-sided copies through the single pass feeder, the 2nd side comes out good with no ghosting/double...
Sorry for not attaching the sample, now attached. However, the issue has been narrowed to the CCD as the duplex copy via the DSPF has the 2nd side ok, no mirroring.
Hi All,
I have MX6240 that produces mirror image/characters when making copy via platen glass and ADF, print is fine. Cleaned optics and update firmware but not difference. Have attached sample,...
To change fax number of rings, you could try this COPIER>FAX>NCU>AUTO RX>00x, where x=number of rings.
Sent from my SM-G901F using Tapatalk
Try updating firmware as well to the latest version.
Hi Ben, well done in resolving this issue and feeding back to us. I have had similar issue before. Just to throw more light on the E074 which you resolved by replacement of the fixing drive assy. The...
Replacing thermo switch, main and sub thermistors may resolve it
Dirty laser slit glass. Clean with the glass cleaning rod.
Sent from my SM-G901F using Tapatalk
Replace main dev/drum drive assy FM4-8390-000
Sent from my SM-G901F using Tapatalk
Thanks. This has been resolved as suggested. Attached info.40865
Sent from my SM-G901F using Tapatalk
Cleaning ITB blade does not often resolve problems related to PCQ, change the blade which is very cheap. Also consider checking the developing assy for replacement.
Has anyone come across the above error, "IEEE 802.1X ERROR, SET THE CORRECT AUTHENTICATION INFORMATION" after firmware update on IRADV6565 from version 25.01 to version 47.04(Uniflow installed)Lower...
Sent from my SM-G901F using Tapatalk
The above code has been reported and checking eMlog noted it to be print server issue. Fix in previous posts on other products varies from checking cables, reloading software on fiery etc. Does...
Just to let you all know that replacement of the DC controller pcb, FM1-H199-000 resolved the problem on this occasion. Thanks.
Thanks for the inputs. Will revert outcome as soon as I get one.
My first job tomorrow with an error code E0733-0000, communication error. Just wondering if is the same resolution as posted with previous versions: DCON or MNCON PCB. Any help is welcome. Thanks.
Indeed the power supply assy resolved the issue. Thank you teckat
Sent from my SM-G901F using Tapatalk
Outlet voltage okay 230V. Neutral to ground within range too. Error came up after a tech replaced film/pressure roller. It's rather the output of power supply that is dodgy, was getting mV at some...
The above error code cleared but still pops up again because fuser does not warm up. Fuser film/rollers remains cold after warming up period then defaults to E0004-0002. No temperature changes in...
Take the laser assy out and give a good clean to mirrors/lens and polygon motor surfaces.
Sent from my SM-G901F using Tapatalk