just install, it will work fine.
Thanks and Regards.
Rashid iqbal
Type: Posts; User: rashid120
just install, it will work fine.
Thanks and Regards.
Rashid iqbal
Dear Friend.
please change this part....PARTS UNIT HIGH VOLTAGE TRANSFER SP....PART NO: 2K994401.i am sure your problem will be solved.Black sensor value is much lower than other...
Dear Friend.....
please try to replace this part...... PARTS UNIT HIGH VOLTAGE TRANSFER SP....PART NO: 2K994401.
In my case only Black was problem....solved by...
My Friend,
please post the sample printouts, so i can guide you what problem exactly is?
Thanks and Regards.
Rashid Iqbal:cool:
My friend,
please try this firmware and let me know.
Firmware upgrade (Main v.007.008 and Engine v.011.001)
Registration problem was solved through this firmware. Gud luck
Thanks and...
Try to replace or clean white roller under CIS. in my case after cleaning white roller problem was solved.
Thanks and Regards.
Rashid:cool:
you are right
MR monstott2010.we found lot of problems with these models because there was no proper toner adhering system in the machine.lots of damage found with tranfer belt,error code C2710...
http://www.copytechnet.com/forums/kyocera-mita-copystar/38623-kyocera-mita-4800w.html?highlight=4800
[QUOTE=luis8832;158567]Working on a km-4800 wide format. Came in on a e-0003 fuser code. Cleared and replaced thermistors on fusing unit. Working fine for 3 days and i am now getting a E-0004 error...
please check the wall socket voltage. 110V or 220V if OK please replace power source PCB.
Thanks and Regards.
Rashid Iqbal:cool:
send me your email id i will send you the firmware.
Rashid.
please update the firmware to the latest.
i older firmware this problem was found.
Thanks and Regards.
Rashid.
Dear Quitech,
check the place of the machine.there is not enough cooling temperature for the machine.provide the recommenced temperature 16 to 20 degree.your problem will be...
please check the front door switch.
Thanks and Regards.
Rashid:cool:
Replace the Thermistor(middle one). same problem found and rectified by changing thermistior.
Thanks and Regards.gud luck
Friend...
Many times i also stuck with this issue...but this problem happens with photocopy from scanner only....Printing is perfect.....even you print 089..color belt...it looks fine....
ok....
Replace HDD(HARD DISK).Your problem will be solved....
good luck.
Please replace the Drum..which color you are facing problem..cyan.magenta,yellow or black.
thanks and regards.
My Friend..
Do not think too much about this problem.this is very common problem in these models etc,250ci,300ci and 500ci family....i will give you very simple solution.enter in simulation....
run simulation-429. Text+photo. Change the cyan value to -2.it will be ok.
Thanks and regards.
Rashid
update the plotter with patch file.
Thanks.
Friends....its is solved by replacing main front PCB assembly.rotary motor is getting 24v from this PCB and i found burned IC on the PCB.
Thanks for your assistance.
i encountered a problem in TAS-300CI error C-1400 at machine start up.if we reset by U-906 Showing jam-00 any Idea? already checked the rotary motor and Sensor working OK.
checked all the service bulletins........no help....thanks....
i faced problem in TAS-8000i registration Jam-4013. i checked the registration sensor,its working fine.the machine done only 5k. copies.before it having problem jam-4208...after updating the...