you can modify a k drum to fit for a colour which takes the cost down
and yes its the charge rollers
Type: Posts; User: jamesyboy
you can modify a k drum to fit for a colour which takes the cost down
and yes its the charge rollers
power supply
network speed?
maybe a long shot but try putting a switch between copier and network socket
has solved weird ones in the past , or set machine to 100
the future is INK, Toner is proving to be a bit nasty
hp pagewide technology
they will be easier to fix
erase lamps would pull dev if faulty
I think I would start at the cassetes ? are they aligned ? is the image moved from all trays
try setting dns to 8.8.8.8
check the interlock switches on the ped door are ok and being switched correctly
6la56960000
case-cst
6la56960000
case-cst
Have you replaced the hdd , might be a good place to start
format the hdd and start all over again
I dont know what I want but I wont it now!!
sounds like the sd board is cattle trucked
thank you : my error code was 065-222 : i have now downloaded a manual so i can progress
help :? xerox d95 error 0065-022 will not allow csi set up !!!
Help : I have 2 colour c70 machines one of the machines does not print cyan in any prints sent, firmware is the same and has been up graded, i can resolve the issue by using a different driver but...
remove or clean the bushing on the front of toner hopper; this is an issue with 224s
the bushing gets clogged and slows or stops preventing the correct toner being added
if its the overlife...
katun chips seem to work had no issues
such errors are usually caused by the front bushing of the toner hoper getting bunged up : easy repair take off covers to reveal toner hopers clean end bushes , machines work ok if the bushing is...
Does anyone know what the power check mode does on a km 951 ?? what is its function
you can pull the driver from the machine \\ etc in run command also in machine settings slow down the network speed to 100 base t
main charge receptacle mounted on rear frame : make sure grid has correct connection
clone file : can you create a file that has the machine settings ie user codes etc to use to back and restore settings or use on multiple installs to give the same settings to each machine
new to konicas : can anyone tell me if you can take a clone file on a konica
swich to print direct : advanced tab in driver switch to direct rather than spool