HI Guys,
I have a MP 301 displaying SC 204 Polygon Motor Error after 30 - 40 prints.
The device has approx 190K on clock.
Print quality perfect until just before SC displayed, then half an image...
Type: Posts; User: MOSSY BOY
HI Guys,
I have a MP 301 displaying SC 204 Polygon Motor Error after 30 - 40 prints.
The device has approx 190K on clock.
Print quality perfect until just before SC displayed, then half an image...
Cheers Polarbear, yep that's the only loom type thing I can see. I have checked and thoroughly cleaned the grounding plates in the area you are referring to. I have a Polygon motor PCB & Door...
Thanks Phil B, I knew it was a long shot, it was just another option for me to look into trying to resolve this issue on a device at the moment.
Niceville318,. Can you be more specific on which ground wire are you referring to???, as I have a MP 301 with SC 204 occurring intermittently. Thanjs in advance.
Hi drwevil,
Are you referring to an @Remote Basil box (100 device) ?
Install and use Firefox to access the GUI.
I had the same issue with IE 11.
Hope this helps.:)
Try reseting network port settings. Set Network security settings to level "0" in Administrator settings.
Try adjusting Security settings .....
User Tools , Admin tools, System settings, Network security Level, to " 0 \ Zero"
This should clear \ open all ports within Network Security.
Hopefully...
Is location 19 that the log is showing the jams ??
I asume that the H & P rollers etc, are in a "good"condition?
Try SP modes listed below, it seems to work for me.
Remember to reboot the...
Hi all,
I have an issue with a MPC 7501 WIM not showing when the address is input into a browser.
There has been no configuration been carried out previously to cause this.
In Smart Device...
Just some things to try, and think about
Looks very like insufficient / uneven pressure.
Is it only happening at the rear or the front of the device.?
There is a motor that engages tha...
Hi Llama God
When you say freezing, is this when selecting the login (CAP) screen, or when you select Prints (ELP-NX), or is it when you release a print job?
If the screen is freezing /...
Hi Llama God.
See below.
SC 636-01- Expanded authentication module error
Posted Mar 15, 2010 3:17 PM
[Symptom]
SC 636-01- Expanded authentication module error
Hi, if this device has a HDD on it take it off or just disconnect it.
try booting up m/c and if ok then your HDD needs formatting, if not its a new controller pwb.
If a format is required,this can...
Hi Guys,
Thank you all for your responces so far.
I was back at the device on Monday, 4 jams logged at 19. Again unable to fault on testing.
Changed the fusing exit sensor, reduced fusing...
Hi Guys,
I have got a Friday afternoon machine that is starting to really frustrate me.
I am a site engineer looking after 50+ devices, (10 x MPC2800) and the last four Friday afternoons a call...
Hi,
Have you done what Choro1dal suggests?,
If you have installed and stored the licence using remote Manager there should be no issue.
I have found that if you try to start ELPNX you get...