F18x its means theres an error at the video control section try to check the harness between main and engine PCB (YC3main YC46 and 50 engine,U 24 format HDD full,U21, engine or main PCB need to be...
Type: Posts; User: kyocera.team
F18x its means theres an error at the video control section try to check the harness between main and engine PCB (YC3main YC46 and 50 engine,U 24 format HDD full,U21, engine or main PCB need to be...
did you tried U906 ?
i think with prescribe command you can reset the counter
print the event log and see what the error code it will help a lot
ufff ..i am fed up still same problem ..???
sub and main PWB has been changed but same problem ,also i change the engine PWB still the same ,H.D.D also ??? and for sure firmware V13 ... any other option ?
thanks
thanks for your reply
i did also ....
i am thinking also about the front main and sub PWB ?
developing unit has been changed by new one but still the same result ? can you please attach the bulletin ..
thanks
I am facing problem with taskAlfa 500ci
the problem is machine keep running over and over until the copy getting very light once i pull out the developers units and shake it
then insert it back...
try u906 first ...
try to change developer if the problem still there you need to change the main PWB
dear
do you have any CFXXX code ? first of all you need to change DIMM panel and DIMM main then upload firmware ...good luck
did you update the NIC scanner system ?
yes you can use computer H.D.D , SATA , but if you add 500GB machine will read it as 160GB only ...
my friend
your problem because the belt scanner motor. check it i can said i'm sure 99.99%
good luck
replace main charge
agreed i can add one more thing after you shaking the DLP k run U 464 AC calibration
how about main charger or high voltage?
its prescribe language the easy way to do that is
first of all you should use KX driver
-printer properties
-device setting
-PDL (use PCL5e )
then open new word file and select prescribe...
did you check if there is an image on the drum if its clear the only thing you need to change the transfer unit
good luck
for scanner you need to install scanner file utility..
for this machine there's no user name and password ,the user name and password in your attached file it's for windows administrator...
dear all
i have problem with canon clc5151 it giving error code E000731
any idea
i think its transfer unit if not try to update firmware
good luck
dear for updating the NC-30 you need to install packet driver (PDINST) then you should have IBVERUP and for sure the last firmware then when you run IBVERUP you will find any NC-30 in your network...