Check paper (test with your own paper, good quality), check paper feed roll.
Good luck!
Type: Posts; User: amadeusmbi
Check paper (test with your own paper, good quality), check paper feed roll.
Good luck!
Clean belt cleaner, verify fuser, verify K drum. Make tests on A3 or SRA3 on all colors from diagnose menu. Post that test here.
Good luck!
you put upside down (rotate, search patch and home position sensor) or not centered (manually center and then "edge belt learning" procedure).
What error you have?
Measure battery (on board). 2.8V is bad... You can replace battery with ordinary one (CR 30xx, or 20xx) 3V Li with few adjustments (wire, soldering...).
Initialize the IOT NVM. If not working, reload software. If still not working... replace the MCU PWB.
clean contact foam (rubber btw t/dt and metal frame, in front) with alchool. wait to dry.
Clean the machine very good. verify trc (values), change drum and put some pictures here.
medium volum - 4110 family (4595, etc)
low volum - 123 (52xx, 53xx)
This are the mule from Xerox (Fuji Xerox have the best eq.)
xerox original toner?
popo (power off, power on)
initialize nvm
Thanks for quick response!
Developer unit has no developer on it? This means that the toner contains developer? I asked the developer because the developer roll brush is thin, tenuous and i have...
Welcome to world problems BLASS (Brunel Leander Alchemy Sterling Sorcery). Paper quality, dry, well-separated (browsing - google translation:))!
Paper pick-up assembly has a "light" operating...
Hi, Do you know the code (part number) for developer (powder) for this equipment. I want to replace the developer and not find the order code. Thank you, Amadeus
what happens when you change paper (change supplier, or try Xerox paper brand new) ?
Welcome to the club :D
You can try to verify connectors but bojans have right...
replace that touchscreen (not entire UI)
why not make it color?
No. Read specification (Laser Toner Cartridges and Supplies for WorkCentre 7132 Multifunction)
001R00588 IBT Belt Cleaner (Transfer Belt Cleaner)
008R13021 Waste Toner Container
008R13023 ...
confirmation number is generated in accordance with machine serial number...
- 113R00674 - Sold (US)
- 113R00673 - Sold (XE)
- 113R00672 - Metered
Service Plan Type
A - Sold
B - Meter
To Change the Service Plan Type
*Obtain the machine serial number.
Fuser fan. Just replace it or repair (bojans post).
Yes, you can reset 2-3 times with no problems. fuser: 1-2 times (until you have duplex problems - jam). cleaner belt 2-3 times (use a vacum to clean, watch the white powder coating on the blade!)
Reseat UI cable.
Try first a calibration of the UI (PO-0, 1,3) then, if it works, try reset 010-320.
Ro
ok, have you try from MPT (Manual Paper Tray; clean feed roll, it may be dirty)? same problems? I have many of this xerox type and never have NVM problem with this error. Usually is a hardware...
replace tray feed assy or try to reseat correctly (verify 3 supports that sustain feed assy).
verify belt and sensor for belt home position.