Thanx Mick,
we had tried it before the sensor was replaced, so hope it resets with the new sensor in stalled...
Much Obliged.
DA
Type: Posts; User: copylaser
Thanx Mick,
we had tried it before the sensor was replaced, so hope it resets with the new sensor in stalled...
Much Obliged.
DA
A little help, does this code need to be reset? I replaced the temp sensor but no help still get code.
Thanx
Can anyone help with the code? I work on most anything but sorry not much of a xerox expert but this customer is in need of help and finances are slim.
Thanx,
Hello CopyTechs,
I am having trouble with the Epson 7800. I am trying to Clear the counter, but it seems that I need the adjustment program. Where can I download the adjustment program? Thanks
I Need help with this Xerox Phaser 8560.
2nd sheet jammed at the registration area.
1st print goes through fine but Jams everytime at second sheet.
Any Ideas why? Thank you.
Hello Copy Techs,
I am having trouble with an Epson 7800 Large format Printer. This is what it is showing
Maintenance mode
Hex dump
language
remaining PRP SETUP
Anyone know what this...
Hello, I tried the "confidential key" and it didnt work. I ran it at the slowest speed and ran a lot of sheets. The master isnt being inked. Could it be the screen? It wasnt inking before thats why I...
Hello copytechs,
I am having a problem with Canon IC MR6530. It is showing an error that says "Download Standby". I unplugged it and plugged it back in. I turned it on while pressing the "reset"...
Thank you! ....Exactly!! haha that's what I did and the cardstock went through, the machine is now placing the master on the drum but now I have another problem....It seems that its not printing...
Thanks for your reply. OK, so I managed to get ink on the screen. I think I found the problem, The master isnt being fed properly. The Master is not advancing onto the cylinder or clamp. Lower roller...
Thank you for replying so quickly. I did hold down the RESET button and it beeped twice. The message that was on the screen cleared, I also cleaned the sensor but when I tried making the master it...
Greeting Copy Techs,
Ive been having a problem with this duplicator. Everytime I want to make a "Master" it shows a message saying "Master remains on print cylinder, pull out print cylinder &...
Guesit would help GR
We removed to clean and now we get master not ejected error
Any one have a manual
Thanks for the suggestions. I did take the xfer sep block apart and did the smell test,couldnt see it arc but I will look again. It just didnt make sense that it would be those blocks but heck I will...
I changed out the charge corona but not the xfer sep corona, do you think it could be those? Its a very consistant line it almost like the laser has something blocking it there but the line is not...
I have a feeling its the charge corona or grid. It does show on print and copy and if a sheet goes thru landscape and I emergancy stop it the line is on the drum but only where the image area is.
feed direction
Its not a blade failure it seem like the laser is not shoting light for the erase to occur.It could be the transfer corona now that you mention it, but the line does not go away after 5 or 10...
The machine has a line down the back where it should be blank area, its not mechanical and show up on drum even if you are running R style. A new line appeared down the middle I reset the machine and...
I had a dealership and always sent my guys to training, some stayed and some left toTRY and compete. Its kind of the same thing I didnt worry about them competing because they will never compare to...
is there a board exchange prgm. are there AC points I can test to be sure of the board?
The energy saver light in not on either. You think it a be the whole op panel?
no sir no fans
Do you have a part # for the operation panel