Hi
I can see from you're pictures that the guide plate that the lower fuser seps attach to is bent.
I've had this problem before as well.
Type: Posts; User: beetle73
Hi
I can see from you're pictures that the guide plate that the lower fuser seps attach to is bent.
I've had this problem before as well.
FYI
Problem solved by installing nvram data from a working machine
Fiery disconnects from machine.
Machine does not go to sleep
Lan is disconnected
fiery is at 00
at 10:45 ish it will disconnect from machine.
Neither machine or fiery loses power
Rebooting machine will re-establish connection.
Happens every day.
Next step is to start...
It disconnects when it is disconnected from the network.
I have tried importing softswitch settings from another working machine as well.
Very weird
Thx for the suggestion
This did not work either
Thx
I will definitely try that
Nope
set to auto update at 3 oclock am
Neither fiery or machine shut-off
just loose connection
Thx for the input
Tried 2 servers with same result
Couldn't find any timers that might cause the issue
Km c1060l with Ic415
Hi all
I have a fiery disconnecting itself from the machine around the same time every day.
Fiery does not crash just disconnects. Turning machine off / on , machine reconnects and all is good...
Unable to set max density
All values are at 2.52
Thx in advance
Hi
Has anyone successfully resolved this issue?
Thx
Thx for all the ideas.
Nothing worked.
Customer upgraded!
Adjust the paper transfer settings under the paper properties
Definitely replace the fuser separating plate if not a finisher issue
Not a bad idea.
Still blowing fuse on the PRCB board.
Wiring harness on order.
Hi
I just had that exact same problem on a BH1250.
The fix was a loose fuser connector at the back of the machine.
On the 1250 take the back cover off and there are screws attaching the connector...
Machine was working fine on the Friday.
Monday morning machine had CC101 code when powered up!
Fans are on but no pre-drive at all
Thx for the info
We did find a blown fuse on the Prcb but have since replaced bd.
Currently ohming out wiring harnesses
Hi
I appreciate the reply but according to the svce manual possible causes are PRCB and OACB which have both been replaced.
Hi all
I have a KM C8000 with a CC101 code
Customer had power issues resulting in this code
Replaced OACB,PRCB,Memoory control bd,2 PS units ,and Nvram from a working machine
Instant code ,...
The fix for this issue is to increase the thickness of the gripper itself.
I took a small piece of rubber and glued one to both grippers. ( separator pad from document feeder works well)
Problem...
Hi
The fuser wiring harnesses need to be replaced!
Hi Everyone
Having trouble with black over spray on all color prints!
Problem only appears in processed black or in color with prints
with a large percentage of black in the color.
Would...