problem has been found to be caused by the duplex/feed sensor PI 17 becoming dirty.
Type: Posts; User: gensys
problem has been found to be caused by the duplex/feed sensor PI 17 becoming dirty.
I check faste toner cluch is good, Plesae help
http://www.copytechnet.com/forums/canon/59685-ir6570-print-copy-poor.html
250,000 maximum monthly print volume
If the iR in a good shape, can print about 5 000 000-7 000 000
How many pages the drum has printed it? Most likely it is more 3000000
http://www.copytechnet.com/forums/showthread.php/38655-Ir5570-light-copyhttp://...
Description
Since the screw tab of the primary fan duct 2 broke, the laser shutter failed to open, thereby causing the error code "E100-0001."
- E100-0001 can be displayed when VLOCK is not...
Before to ask a question, use search...
http://www.copytechnet.com/forums/canon/44529-ir5570-waste-toner-container.html
For iRC 6800 series (iR C6800C / iR C6800CN / iR 5800C / iR 5800CN)
E009-00FF Error Code: Because of broken 24T gear in fixing drive unit
Cause
The possible causes of the detail code "00FF"...
http://www.copytechnet.com/forums/canon/61105-show-ir5075-e423.html
Abnormally high temperature (detected by sub thermistor)
The sub thermistor detected an abnormally high temperature (300 deg C) during temperature control.
Check sub thermistor
Check the...
http://www.copytechnet.com/forums/canon/53599-canon-ir5570-error.html
http://www.copytechnet.com/forums/canon/63461-e733.html
Use search
Replace thermoswitch by a new one
Be sure to screw thermoswitch firmly. If the screw is loosened, there will be no gap between thermoswitch and the fixing roller, letting thermoswitch have an...
User Mode> Common Settings
between - job shift.....OFF
between - job interleaf .....OFF
between - set interleaf .....OFF
First of all use search of this site
call a service center
Read This >>>>>
iR3045
Select >>> Operation System
Select >>> Language
Submit
old, good np1215 :)
15002
http://www.youtube.com/watch?v=qBjQt9LjgdE
Read This....
http://www.copytechnet.com/forums/canon/38655-ir5570-light-copy-2.html
15001
Need to Read Forum Rules
Change or clean thermistor
Е000 - The fixing temperature fails to increase.
• The temperature detected by the thermistor (TH1) is not 65°C in 1.5 sec after the Copy Start key is pressed.
• The...
How many pages the drum has printed it? Most likely it is more 3000000
http://www.copytechnet.com/forums/canon/60815-need-sst-firmware-ir6000.html
http://www.copytechnet.com/forums/canon/3611-canon-service-support-tool.html
Thank YOU
If the fixing motor (M19) is normally rotated by rotating the fixing knob lightly during warm-up rotation, it is possible that torque of the motor (FH6-1996) became insufficient. So, replace it with...