I am a bit baffled, the 7551 Was reported as jamming. I tested the machine and found that it works 100% when doing black & white copies or prints from all trays including A3 and A4r landscape and...
Type: Posts; User: Dutchman
I am a bit baffled, the 7551 Was reported as jamming. I tested the machine and found that it works 100% when doing black & white copies or prints from all trays including A3 and A4r landscape and...
I have a Laserbase MF5770 that switches on without error how ever the LCD is blank no info displayed. Would this be a display fault or is it a board fault.
Any help would be appreciated.
I have had this a view times as well. Have normally replaced the drum causing the problem again and that normally solved the problem. Make sure that the patch sensor is clean. Apparently they say...
The inside of your drum developing area the P-Kit is dirty and causes the machine to arc. you need to take out all the developers and vac out the area especially the dev that has dropped to the...
Dear colleague,
Herewith attached a PDF that will assist.30170
Banding on a C1 normally comes from a gear or drive that creates the judder. I would check the following:
1) Fuser drive gears, 2) drum and developer drive at the back behind the flywheel, 3) ITB...
Check the dail on the paper tray if that is set correctly with the paper used in that tray.
Strip and clean or chance the switches on the keyboard circuit board.
Be sure to clear the error in service mode: Copier - Function - Clear - Error
My wife and I are wanting to relocate to Denia/Javea Spain mainland.
I am looking for a service engineer full time or part time position in the Denia/Javea mainland Spain and I am prepared to...
If the calibration passed then I would not worry about the lower reading on the yellow. If you want the yellow to be more in line with the other colours then I would add toner in service mode and...
Hi,
Try the (sens-init) function in service mode selecting the feeder then function - Sens-init.
Hi,
If your machine is without a fiery then you would do the setup by using additional functions and go to network settings, If you C1 has a fiery then use setup on the fiery to alter the network...
Thats right Zoraldinho E805 is fan related. Either exhaust fan or cleaner fan.
I would stip the pickup assembly and check if all is ok. Are you using FF5-4552 for pickup and feed and FF5-4634 or FC6-6661 for sep.
You might have a faulty clutch on the paperfeed drive system, if not then replace the pickup assembly
Does the machine copy at all, If it does print or copy do a p-print and clear the DC controller in service mode. That should clear the problem.
If there is a problem with one of the PCB's the machine will error and will show a error code. With that error code a person can rectify the problem.
Glad its fixed. thanks for your reply
Hi Thadwald, There are a couple of things that could cause blank areas. Check and see if the developer is evenly spread across the dev. roller sometimes there is hard toner just before the doctor...
Thanks Have done: Now sorted:)
Hi, I am attending to a Xerox Dc250 with a fuser error. I replaced the fuser unit with another good used unit and tried to reset 744 156 in the NVM to 0 but it won't accept the reset. The present...
Hi, Are you sure the Error is E761 and not E716. :confused:
Errors E7XX is normally a communication problem with a peripheral or other unit with machine.
Herewith some more info regarding why the parts were modified
Item 9:
Part number FM2-4354-010