i have it. let me know if you still need it.
Type: Posts; User: tack
i have it. let me know if you still need it.
i finally got the software installed using executable usb flash drive using fiery usb setup tool.
the trick, which does not make sense to me, is that the dip switches have to remain in the normal...
i may be mistaken but make sure the copier is connected and on when you try to load the disk.
your ghost image should also work.
i did the same with a fiery H1
there is a fiery clone tool...
on mine i put the first disc in the cd tray and turned the imagepass off.
then leave it in and turn the imagepass on.
it should boot from the disc and load.
it will direct you to install...
anybody know the procedure to reload the operating system on a FieryIC-405/Fiery X3ETY using a flash drive?
i have this Fiery showing FF and not recognized by the C500
i have the os discs so i...
I put in a brand new exact same HD
I still get installation timeout.
Anybody have link to usb flash installer software?
Or any suggestions?
thanks, i am going to get a new hard drive.
maybe that is my problem.
thanks for your reply!
i tried installation of system software.
i connected my laptop to the fiery with a crossover cable.
made sure both dip switches were in the service mode. (both down)
powered up fiery...
thank you very much. i tried on a faster connection and i think i have it now.!.
i burned 2 disc iso.
i will try system software re-installation.
Thank you very much for your effort.
27791
here is what i get. no system code tab.
maybe i have to be logged in as IT tech or something?
i believe those are drivers only.
hi,
i tried the link.
i get message folder is corrupt or invalid.
can you check it?
many thanks!
hi. i went to the site with a konica minolta support site.
i dont see the system software as an option to download.
do you have a link?
Hi,
I am in need of
FieryIC-405/Fiery X3ETY software installation CDs .Can I get them from you?
Thanks
oh sure, i will share what info i find.
i have a hard drive from another one.
i saw some on ebay for 350 or make offer.
pretty high considering age
thanks.
hi,
i am working on an old km c500.
the rip hangs on FF during startup
i think i need to reinstall software.
does anybody have a source for the CD's?
many thanks.
(yes i know this is an...
turned out to be a slightly bent exit sensorbracket that did not allow flag to trip the sensor completely.
i have intermittent j32-01 code.
i replaced sensor and motor control board.
machine works for a while then code returns.
any suggestions?
thanks!
thanks! i will try all of this. i also have a hardrive from a scrapped H1 i will try to transplant. thank you!
thanks!
i will try that position with switches.
i tried the whole procedure changing the img-cont from 3 to 0 to 3 again using the correct shut down procedure.
after i hold down the power button on the machine and tell it to begin shut down...
hi yes, i have messed around with the switches so much i cant remember.
what is normal dip switch position?
what is the dip switch position for installing software cd's?
thanks for your...
thanks! i will try it over again using the correct shut down procedure.
what position should the dip switches be in when switching the IMG-CONT back to 0 AND back to 3?
What position should...
i just tried pinging the H1.
it times out without communication.
i tried the procedure
2 things>
1. i can not follow the normal shutdown procedure (options are not available from control panel because i never get the prompt. i shut down with sub power and...