You could do 2 things, either manually select the drawer that your using the 8.5 x 13, or put the paper in the bypass, set a custom paper size, but still you may have to manually select it. If you do...
Type: Posts; User: copierdude1
You could do 2 things, either manually select the drawer that your using the 8.5 x 13, or put the paper in the bypass, set a custom paper size, but still you may have to manually select it. If you do...
Im sorry, im not understanding what your trying to accomplish. Maybe you could elaborate. What is the issue your having?
Enter Tech. Rep. Mode, next enter tech. rep. choice, next enter system set, next select from your 4 sizes.
Hope this helps.
Could be a lot of things. Are you running after market toner? If you reset the I.U. with out an actual replacment, did you check you toner levels first? Is the toner path clogged? (seen it with after...
I'd be more than happy to e-mail you a copy. Also, you dont need to replace it. The transfer belt has a fuse on it that can easily be replaced. If you pull the unit out and unscrew the assembly that...
Your right, replace the pi3502 but keep the smart card and memory.
Ok, check the memory on the pi3502. There should be added memory for scanning. If this goes bad the machine may not recognize scanning. Other than this, your right, replace the pi3502. Make sure you...
ok, the machine also takes special memory for scanning that gets added to the pi3502, if this goes bad the machine wont recognize scanning. Other than this, replce the pi3502, keep smart card and...
Talaloo is correct, inspect the charge corona and make sure it is installed correctly. Another possablilty is that the copier has been ran after an out of toner condition. This damages the developer....
The Image Unit is inside the left side door. You should either order a new one or order a rebuild kit for it. If it was still making good copies you can cheat it by simply replacing the pico fuse. If...
Do you have the service manual? It provides some insight into this malfuntion. If you need it, i'd be happy to provide it for free. Just contact me.
If you take the pi3502 print controller, you'll notice that the board inside has a scan disk installed underneath it. If you replaced the pi3502 and did not swap these, it will not be able to scan as...