Thank you all for replying. Here is what solved my problem. I must admit I felt like a rookie upon discovering the cause.
Discovered torn image belt at root of jamming. It gave no indication of...
Type: Posts; User: wilez
Thank you all for replying. Here is what solved my problem. I must admit I felt like a rookie upon discovering the cause.
Discovered torn image belt at root of jamming. It gave no indication of...
No longer have parts for that box. But the first I had to replace it I matched it with gears I stripped from a ricoh c5501. typically around the duplex or paper feed drive use gears similar to that...
This C450i jam at fuser rollers (not turning), no errors message or indication prior to problem. It worked until midday then started showing J-3003 codes until they requested service. Can manualy...
Do it fade or repeat image? If ghosting then check as mentioned above, but if fading, look at 2nd transfer roller and developer.
So to end this thread. After going component level found a voltage rectifier shorted thus blowing fuse F001. DC board was replaced and I added a line monitor just to see if dirty power or power surge...
Hey guys asking this question due to tech support was not much help.
New out of box BP-70C45 at end user site less than 2 weeks and has a bad DC power supply (it is on a Innova surge protector)....
Ditto!:cool:
Search this site, someone has posted a list. but be aware it is with toners needed for there purpose. But I have done as mentioned above and matched ingredients. Good luck!
Out of warranty. I looked also and came to same conclusion on this gear. The C652 gear woiuld wear premature and i believe KMBS later offered that gear as a part.
I have not had this happen on the 4...
Here is a picture of the belt drive gear.57391
Do the 26T gear for the C759 fuser have a part number? Checked my catalog (2018 version), shows no part number the 26T gear.
Looked on SSD for bulletins related and "one stop" for updated catalog...
Telegram: Contact @pump_upp - best crypto pumps on telegram Make 1000% and more within 1 day, join channel @pump_upp !
Telegram: Contact @pump_upp - best crypto pumps on telegram Make 1000% and more within 1 day, join channel @pump_upp !
Telegram: Contact @pump_upp - best crypto pumps on telegram Make 1000% and more within 1 day, join channel @pump_upp !
Did 2 few months ago. They run dirty, spent more time cleaning than replacing parts. You may want to do MC-6307 main charge assemly (precision roller) also. I did main charge and developer DV-6305 on...
This repair started with e00025-001. Removed K hopper and cleaned toner hopper sensor, reinstalled everything and upon power up e00066-001. Checked pre transfer shutter movement, clean the sensor...
Greatly appreciate it for service manual on imagerunner C7580i.
Thanks!
Weak exposure lamp or power output to lamp is not enough get full brightness. Clean and inspect optics and check SC's for exposure errors.
That model was known to have mag brush ground and drum ground issues on high meters. Also if using aftermarket drums and toner will cause overtoning. as mentioned above start from scratch if possile....
Called tech support and this is the file they sent me( A7950Y0-A900-G00-01_AU-102 ) is this the correct file for the C759?
Thanks
I am asking here as that I have looked at Muratec tech portal for any special firmware or loadable drivers files for each model down to the C224 (not on our site). Have to add the AU-102 v4 to a...
Hello fellow tech's
I can use some help. Customer has a Kip 700M after printing page will keep job in que and few minutes later reprint job again, minutes later print print it again then it may...
slimslob
http://www.copytechnet.com/forums/images/statusicon/user-online.png
Re: MP C4002 usb media port
http://www.copytechnet.com/forums/images/misc/quote_icon.png Originally Posted by...
No! different touchscreen. As a swap use MP3035 or 3045. or try the mp3500/4500 panel
Sent to a estudio 352 when powering on says "TEST MODE UA" do not find any reference of this in service manual. How is this reset or cleared?