Search:

I agree. Starts witha smiley face ,ends with disgust.

In level 2 adjust fxsmr to a greater value .It helps take out the nasty curl after the fuser .You may have to adjust dev ofst to a more negitive number if the cq is shadowing after the adjustment.

Thanks guys . We use OEM drums and canon fuser units. So really the only way to make money is to use aftermarket drums and fuser units ?

Im trying to cut the cost of doing repairs on the 5180 for my incentive program and I cant figure out how the national average is that low . Four Canon drums billed to me are $2000 dollars . $1200...

Thank you 11x17 I should have done a search. Ive read your past post .Ahhhhh I remember those days . Not the same now is it ?

I was wondering who has it and how they like it ? Has it gone from a bonus to your raise ? Ect....

Like to hear all the good and bad and how did it start first and how is it now ?

thanks

you can use the 105 fuser kit. the lwr roller is not the same on the 7105 but you can use the 105 ive seen no diff when using the lwr roller in the kit.

I think we are over the hump with the films .I havent put one in for two weeks . doesnt seem like a long time but I have over 200 just in my territory.

I was about to add the Savin liquids. When I started in the biz thats what I was broke in on . The kerosen dispersent saved me from buying afew carpets. I used have to clean the tanks so we could...

Tru That! Tru That!

Have you ever replaced the UFR on 5570 before ? Its a good for a super tech:cool: . Also remeber to lube your LFR ends with high temp grease before you put the bearings back...

First clean your and replace all your corona wires . cuz that just good hygene. Once you have done this reach behind the tranfer /sep unit and find the bias connector for the fuser unit . Now snap it...

fixed

Do a staple job of 101 sets of two . When tray B hits 100 stapled sets it will lower for tray A . See if it codes out then.

Is it a K3 or a K1/2 ?

Remove the staple remover from the tray height sensor before it burns out your fuse PCB .

I dont know what the hell you are tring to say . But yes canon has changed the material they use I was getting 200k out of my units until recent . todays unit did have the brown film .I install only...

The new films are bad . We were asked in a meeting if we notice the films tearing ,I belive the brown films . Anyways yes they tear , yes they new stock is bad and I think the katun film is what...