Gary ...
Type: Posts; User: Si@danwood
Gary ...
You have heard correctly ,am at this moment on the Uk training course and they are running on Linux
Can you verify the model name! The c500 doesnt have a fuser belt,the c5500/C5501 does! may help you in sourcing the parts!
Good one will try that!!! Let you know what happens!
Got Exacyly the same thing on a b/hub pro 920! However when i went in to retreive the config page and test pages they printed the graphics but there was no text on the sheets! RE-printed them and...
Keep some toner in stock and make sure you reorder in time! Works wonders!!!!
Its already been said it still jams with the finisher disconnected! It sounds like the exit sensor!(The one on the right hand vertical unit FFS near the orange/yellow gate assy!) They tend to warp...
you wont!!! From here on in it is a case of identifying which icp it may be locating the corresponding pwb then looking for it .They usually have an identifying mark next to them(icp24 ,icp25...
ok an icp is like a surface mounted fuse used to protect more expensive/delicate component on a circuit pwb.Give me a few minutes i have an icp list somewhere. Although KM release this list for...
Not good news i'm afraid :-{
First thing i would check is that everything went back in correctly! When you pushed the process section back in was there much resistance?Is the drum nut located correctly? has the blade flipped...
Sent you a pm as soon as i hear back the info is yours
Try just reloading the system software,this is on a disk that will have been supplied with Fiery.It takes about an hour and 3/4 and will be the fastest way of getting the machine working,whilst you...
lol good ask
Any machine can be repaired,just at what cost is the real issue! This code relates to magenta dot diameter adjustment control failure.Now this could be any one of a number things causing the error...
Shed loads!!! But contray to my nic i aint at Danwood anymore
Yep the dehumidefier's were both installed without the three pin ac power harness plugged in!!!! Connected up and working a treat! Thanks
Okay New install,both machines installed with lu-202 and HT503 tray dehumidifer's upto spec with f/ware Both giving C-0418 when set for coated stock! I know there is a bulletin for this and the fix...
Always works for me,a tip i picked up along the way. Saves money on new drum and developer but be sure to test a 100 or so before leaving the customer
set atdc value to 85, problem sorted ...simples!!
Good Man ..feel better now?:)
10871087 ? Been a while since i worked on kyocera but am sure it will have remained the same...si
KM would be the 1st place i'd start:D:D. Seriously though it may be worth contacting a local/friendly KM approved dealership who may be able to help you if you have'nt an account with KM yourself..Si
Try opening and firmly reclosing the toner delivery unit(The one that swings out to the right of the machine so you can get to the process section) I have had exactly what you describe on a few...
4520 relates to colour registration abnormality. I would say that you have an issue with the transfer belt Asy,most likely the belt will have "shifted" either to the front or rear of the unit.You may...