Machine is during warming up state after copying every two sets for 20sec on following condition:
Note: Machine has not finisher.
İf you choose duplex and sort criss-cross, machine waits 20...
Type: Posts; User: minolta35
Machine is during warming up state after copying every two sets for 20sec on following condition:
Note: Machine has not finisher.
İf you choose duplex and sort criss-cross, machine waits 20...
there is no any subject about service mode password resetting in manual.
Lift motor turns when the cassette out.I've change the switch but still works.
Hi,
The machine display shows a paper back of 1st casette as ssoon as place the casette.Lift motor and paper out sensor work well.I've change lift motor 2nd casette.Still problem same castte.
No...
The copies become grey.I put in dev unit some toner and made sim 130.But problem still goes on.I checked toner motor is ok.I want to adjust td sensor value.To check more toner adding sim 131 higher...
I have an EPSON MX20DN all-in one machine.I tought its the same machine with Kyocera 1128, but firmware is different :D.
There for 1087 made anything.I'll be waiting for answers...I'll be happy if...
I need Riso KS 500-800 service manual .
I have some copier's manual send you too if you send .
minolta35@gmail.com
Flashing LED's means ''scanner pin-photo error 4200'' written in user manual.What does it mean?
Is this laser diode problem?
This is same machine with UTAX cd1316 or Olivetti 164MF
Flat cable was broken maybe...
Noone has any idea i think...strange...
My custumer has 2 KM 1620 and 2 KM 1630 and wants to make copy ID card (A6 sizes) both sizes onto an A5 paper.It does not matter A5 from cassette or by feeding.
Could you explain me to do this...
feeder was removed and code still goes on
I had same problem.Customer cleaned the machine with air blower.And sc 471...
When I want to make a copy or fax scanner moves to right and ''unlock scanner'' message on LCD after the machine waits 1-2 hours in standby mode.I turn the machine off and wait a few hours.Then on...
Is that true?Any other comment...
OK I'll check it again.
Interlock switch works well.is it resetable code?
I've change a gear rear of the machine and when power on displays P51?What does it mean?It can be reset_?
Last paper jams (not jam, machine stops when the last paper's end is on exit switch) when making multicopies.
Same thing happens often making 1 copy.
I change registration sensor with by-pass...
I've got a 1216 display P25 and P26.I don't know its mean and how it fix or reset it?
thanks a lot.
Most usefull...
After chaging drum and developer how to reset P24 error and how to dev.adj.
Main motor blocked or defective I think...
Need help Xerox 5825 to enter service mode to reset U4-6 code...
Thanks a lot...
Best regard...