Search:

Hi tried checking anything like that.
I've spoke to a friend at Kyocera and they have never had it.
The machine initialises but screen and buttons dead no ready light etc.

Hi,

I have a customer with with FS3040 and the machine comes to life but the buttons and display are dead.
Any ideas?

Thank you Spanky I'll give it a try x

Hi i have a MX2640 that keeps getting the web jammed. (Estate agent)
The first we know is when the machine makes a noise as the webs stuck.

The web gets moved by a solenoid and we have checked...

We have loads of these and they go wayyyyyy past pm counts.
Only real issue we have is fuser jams when users use cheap paper and lots of colour.
Feed tyres are £30 a set and last 80 to 90k so worth...

Hi has anyone every had random toner spots on print outs.
On arrival it seems ok but I've found a lot waste toner in the back of the drums.


Any ideas?

Hi if you go to so system menu
second page press date/time /energy saver

login in

Admin
Admin

second page sleep rules and switch them all to off.

Hi All,
Can you advise?

i have a mx-314O and the doc feeder jams at sppd2 not reached.
the sensors all work and when I do an ageing test it works to.
HELP!!

Regards,

dave.

Hi there,
does it have an internal finisher? If so the rear bearing sweek.
ive also had the bearing at the bottom rear of right door doing it when feeding.
bit of oil a spot on.

good luck

Me too

Just joined UTAX from a Ricoh background.

Welcome

Ahh you see there is a difference.
The machine will stop working if the PM count for say the fuser rollers get to 300k
This never happened on the old kit.
I think I may have afix.

5062
[Parts...

Hi All,

Can you help we have MPC4501 that comes to a stop when the PM life is up.
What can we switch off to perminatly stop this.


Dave.

I did 107 it and it worked for 17 copies then it just went to normal screen and the start key started flashing red/green and I froze agai

Hi all
i have an mpc2500 with a start key flashing red and green.
Can anyone help?
Dave.

SC565 we got our engineer who said he checked everything to check the pressure roller thermostat and it was blown.
Even though it came to power up and ready then after 5 minutes threw the code....

Brilliant thank you

I had a similar problem recently where after the machine was left to go to standby or first thing in the morning it would jam a couple of times it would jam entering the fuser. I found the gear that...

Hi There,
I just installed a MPC3001 with an SR3050 and the saleman pulled the finisher out the box badly causing SC798. This was due to the upper limit sensor of the output tray being jammed...