clean CIS senzor and do setup. than change 746-939 and 746-940 to 50 this move the marks to the edge of the paper.
BB
Type: Posts; User: fogra27
clean CIS senzor and do setup. than change 746-939 and 746-940 to 50 this move the marks to the edge of the paper.
BB
install the newest service documentation... there is adj. 9.14
Service Documentation>>>
ADJ 9.14 IOT Slow Scan (SS) Magnification Adjustment
you're welcome
first clean ROS then check metering blade in developer housing.
Cau...
Fuser Nip
adj.8.1.1
WCP 56XX
Scaning Kit
A: 23100800
B: 42897946
what type of paper you use?? RML Xerox paper?? I have similar problem but the paper was not for laser printing. The customer use cheaper paper for offset lithography. Yes colotech is more expensive...
use PWS. Then DC 132....
Laser unit is bad.... (ROS)
- it is a hardware option you need a boar and a cable between SIP and NC.
And the PIN is
Scaning Kit A: 23100800 B: 42897946
BB
part list 2.7 item 30
1) flip over and reseat the thick cable from fiery to machine
2) reinstall fiery SW
3) reset nvm in the machine...
cheers...
disable firewal, antivirus. You must use the correct alterboot for WCP35... And the SW 3.98.50 is ok. You must use a null modem serial cable and crossover cable....
I can upload altboot files and SW...
to enter diagnostic hold # * and Stop, then 6789.....
check NVM 715-400. 0 disable DADF and 1 enable DADF.
-you can not remove the yellow dots....
install latest FW with altboot and apply patch V3_H2H. Only for lexington II, 040.033.xxxxx Mostly this will help.
calibrate the machine, with calibrator or from platen glass. calibrator is better :)
white gear broken on the elevetor motor. you can order and replace only the gear.
hmmm.... the changed door is new ??? or used?? there is a one way clutch at the end of the exit rolls but after the 2nd sensor. When the changed door is new so i have no idea. Maybe the faul code can...
can you post a picture of the jamed paper ??
But when you print simplex and you dont have changed print from face down to face up the machine use the inverter !!! so that the copies printed out...
just back up the bottom hinge with some piece of metal, the door with the OCT is too heavy and the hinge is bend down. The door must close absolutely freely without any obstruction.
1. disable the option on the UI, it is still activ but customer wont see it on the panel.
or
2. Initialize NVM.
run dc 675 RegiCon Setup Cycle Control, check MOB senzor.