Hi
it turns that both cpub and strgb are defective.
BR
Type: Posts; User: ivovb
Hi
it turns that both cpub and strgb are defective.
BR
Right here I would like to cry my heart out. On the point where new SSD is setted up in the machine and boot rom has to be upgraded bloody scamp come up with "firmware error occurred" (excuse my...
Hi, there.
Many times I was thinking about setting up website with greatest customers bugs. Still not ready (of course). But here I can not help myself.
Phone call. No paper source is working...
You are so right. Thank You. I'll give it a try.
BR
Hi again. I'm talking that pos 13 - it prevents FS's connection.
55076
Did You only remove extra flapper - A87K822300 Rotation Guide or there is something more to do?
BR
Only for TOP GUNs! Is it possible (if yes how?) to connect FS-536 to BHC250i using RU-513 version A87JWY1 (not A87JWY2)?
BR
Procedure that works
1. Upgrade to K8.
2. SS25 > HEX30. Restart.
3. [Utility] > [Administrator] > [Maintenance] > [Authorization function Setting]:[Install License]
Now You have AirPrint v2.1...
It seems to me that this topic is not concluded. So I'll resurect it. Moreover I have proved solution. After battery lost on MFPB, i've changed it and get this error. It is because I've forgot to...
Same problem here - J3003 on long runs, sometimes... Have to go tomorrow. I has intention firstly giving a chance to WD40. Thank You tsbservice for pointing the issue.
BR
Hi everyone!
It is fuser if You can confirm next one. When You print demo page with bird pull out transfer belt and You can see ghost image of demo on belt which is correct - no shifting.
BR
Absolutely agree.
Does anyone already uses some aftermarket SSD successfully instead of KM one's?
I have several similar cases with C250i, but upgrading to 45/75 firmwares solves the problem....
MFP board abort code. Check/reconnect all of the connectors to the MFP board.
BR
Check/clean/set contacts concerning drum chip and HV contacts, too.
BR
Starting machine with Power key pressed will cause Self diagnostic. So check if Power key is somehow constantly blocked.
BR
TPM issue and zero counters whispers battery problem. Did You check battery voltage on MFPB. It must be 3v, not 0.5 V or so...
BR
Use latest firmware G00-7D. Two of the predecessors targeted a print quality proplems.
BR
SafeQ, PaperCut or LK-114?
BR
Here is some update on my case. First of all many thanks to Gergo. Secondly Yes it is not needed to order any spare parts from KM, just 3 euro aftermarket battery 3V 2477. It is obviously that KM...
Hello,
I've faced same problem today and do some investigation myself... In EU version of document concerning firmware there is statement:
"It is not necessary to use the countermeasure firmware...
Salut, ça va?
Check #1 and #3 in service manual:
#1 Cables are often too tense
#3 it is quite old machine and if You didn't clean optics it is time. Moreover Paris is not so clear air...
BR...
Yes You are right and it is not only KM, but Toshiba, Brother, HP etc. I have several times of a wrong procedures concerning replacement electronic parts or solving a problem. Quite often expirience...
Have seen several times such a problem. All the times decision is as follows.
1. Remove Gate switch unit using chapter 5.7.2 in SM
2. Look at the last photo in procedure - especially gate switch...
That's my point. All of my cases are as described in first post leads to SSD exchange, firmware update and problem removal.
BR
You need X4 firmware to get rid of the problem.
BR