Have you replaced the ITB unit ?
Maybe the inner transfer roller within the ITB belt for black is dirty, causing a jump on every rotation.
Type: Posts; User: Borsody75
Have you replaced the ITB unit ?
Maybe the inner transfer roller within the ITB belt for black is dirty, causing a jump on every rotation.
Hi
If the laser glass dirty, makes horizontal lines
Measure the distance of the lines to count the diameter of the part which can cause the problem.
Hi,
You have to clean the registration rollers contact plate, which located on its left side, after the right door opening.
There are some black grease between the plate and the roller causing...
Try this
3439534395
I used sometimes clear silicon grease
Hello V-P
Until now I made more than 20 modificated console, and maybe 1 doesn't solved the problem.
If the fixing unit with this modification became noisy you have to pull out on the back side a...
Yes you can.
Download the user manual,it will help you
Hi Teckat,
I recovered the machine.
The method:
First you have to find an other Canon iRADV400i for DONOR, which Main Controller version maximum "8" (Press the Counter Check Key on the LUI...
Thank you Teckat
Tapatalk-kal küldve az én SM-G357FZ-el
Hello
I have a problem with 2 brand new Canon iRADV400.
My colleague wanted to install the local language (HU), but he had it only for the 7.01 version.
He downgraded from 23.01 to 7.01
Now...
Sorry, you should ask your Local Canon dealer
Hello Lui from Bolivia,
Upgrade the software to 48.02
It is brand new, and Canon promise it can solve your problem.
3 years ago it was a great problem.
The worst case was a 3235 which teared its film at counter 30.000
At first we changed only the film to non OEM.
After 1000 copies it went wrong.
Then we...
In the case of fixing film goes front, and tears, with the modified back console you have 90% chance of errorless working.
Hello Dan Dryer,
I had E191 yesterday in an iR3035, and the problem was a contact error at the finisher S1 cable.
Thanks
25448
Hello everybody
This bulletin was updated.
Canon modified the modification.
You are not able to order cassette lock arm stopper, look at the attachment for the new part.
Hi Helio
I have bad news.
We had more than 5 Mn Controller changed with this unerasable print job problem.
With a brand new Controller the problem solved.
If you have another client which...
Sorry, the second picture was wrong...
This is a modified rear alignment plate:
14139
I have some Canon iR3235/45 modells with the same problem.
At the first time I change only the film (non OEM)
Second time I change the fixing film unit (FM3-7071) and the pressure roller...
No error codes, no jam codes.
I can attach a Video of the malfunction.
In the Video the papers coming out from the finisher without any moving of the stack slider.
As you can see at the end of...
Hello
I have a problem with Finisher S1 on iR32xx series.
The machine works well.
It goes to energy comsumption mode.
After 2 hours of sleeping a user starts a print job.
The machine started...
Maybe any connected thing on the reader controller has a short circuit. Try to remove one connector from reader controller, and switch on the machine. If nothing changes, switch off, and reconnect...
Here is the
General Timing Chart / General
Circuit Diagram
for
iR2422/2420/2320/2318 Series
When I had the same problem with iR2018, the reader controller was wrong, caused by overwatering...
Congratulations too.......
Maybe this can also help you:
In my experience some iR2016-2020 could have a faulty cassette feed clutch (CL202, FK2-1068 ).
It can cause different types of jams, and the machine can complain...