you just cdlone with hd clone from a working hardisk of same model dear
Type: Posts; User: vj200729
you just cdlone with hd clone from a working hardisk of same model dear
dear friends can anybody give me xerox workcentre 7428 servicemanual my email vj200729@yahoo.com
can anybody sujjest any way to increase data transfer speed from computer to wc7345 .i am no using pcl driver now
sir ihave cleaned fixing unit thermistor
kyocera 6025 showing error6050 intermitentily.i have cleaned thermister ,but problem repeats on taking copies intermitentily. pls respond if any sujjetions.
the wire connecting sensor to chaise may be damaged
no, in a3 also only top edge is light for 2 inch
in a3 also only top edge one inch light
same on printing and copiying
may be heater thermister touching heatroller aluminium sice teflon coating damaged
in one kyocera 1635 lead edge 2 inch is too light.i have replaced drum unit,dev unit,transfer assemply,high voltage board etc .but not any change.pls sugesst any solution
in a 6570 belt no sm699 which drives toner unit and waste mechanism is going comtinusly brocken.on physical inspection toner unit is free.pls help
can anybody tell any way to reset cz 180 ink tag so that remainging ink can be used.
in one ir6570 paper gets jam at fixing unit,when duplex copies are taken and it happens intermittently only ,and when it happens one paper with single side print comes half out of fixing unit paper...
My Canon 3300 is intermittently showing E732-001 I have interchanged MSP Board, dc controle board HDD but the result is same can anybody give any suggestions
sir, i cant understand the logic in it.are you jocking or telling seriously,i cant understand
i use to change ir3570 heater filament and it does not last.what happens is it get broken 3 inches from pressure roller big gear side an arcing happens.i changed pressure roller,roller bearing ,but...
E315 is usually ip board faulty.you check is there any extra sd ram added in ip board,if so remove it and check problem is coming.
you have checked heating unit?ie:pressure roller may be damaged ,film may be tight with grease dried out.
replace filim
i use to get this problem occasionally and i solve it by replacing drum.you try same.
in some machines of ir 400 if i use lg toner it starts to over flow and make designs on copy.i tried by emptying and blowing out all toner on cd unit.then also same result.can anybody suggest any...
may be the solenoid in exit unit not properly working.
i cant understand what you are expecting.my simple suggestion is enter data's using service mode:
can anybody suggest any practical way to insulate a leaking end block of any model of machines.