J003 problem happened again. put in a new tandem right side tray. Hope this fixes it.
Type: Posts; User: totoro
J003 problem happened again. put in a new tandem right side tray. Hope this fixes it.
update to latest firmware or reflash if already there
if it's taking a long time to copy and print , I would probably look at the HDDs.
I went out there yesterday and found that when i manually lifted the tray the rear right side of tray was about 2mm lower than the front. i shimmed the rear as I could find nothing wrong with the...
I did not change just the sep roller. I put in a new feed unit .
I have watched customer load paper in the tray and they do it better than I do. It has to be some mechanical problem that i'm missing, but thanx for the imput.
will be back there soon and let you know. thanx
Paper in tray is being loaded correctly. Paper feed unit was new. There is an adj for sep roller pressure that I have never used. I may try that. could this be a problem with the try lift? Tray seems...
no paper behind tray, end and side fences look fine. Paper is loaded good. I thought this model used motors for feeding , not clutches. I know that there is a feed motor on the feed unit itself, but...
Hey guys, I have a mp6503 with an intermittent J003 problem. No toner dropping from dev unit and meter at 700k. Have gone in and switched T1 and T2 feed units as customer says they can run their jobs...
is the toner bottle turning?
Is the firmware up to date? Wasn't there something about setting the paper type to the one like " no display " ? I thought it was a glitch in the 2200 that they fixed in the 2201.
so you changed the waste toner bottle. did you check the sensor?
Let's go back to basics here. What are your values for vsg and vsp? Is there toner\developer in the developer unit. Do you get an image on the drum doing a panic stop. So many varibles.
If you've swapped the connectors and then it works ; I would go for the board that's sending the on signal.
That comment was totally uncalled for. This is a forum for techs. A trained tech would understand the instructions given. If you don"t understand then you are either an end user or an untrained tech....
Have you updated to the most current print driver? I have had sc899 after updating firmware and resolved it by updating to newest driver.
Check your dns. Anytime I've had issues with computer names it's been a dns issue.
Someone correct me if i'm wrong, but don't the lube bars in the pcu cleaning units have end detection tabs, and sensors on them so that you can't just reset the counters to clear the message? I think...
Have you followed the J098 troubleshooting steps in the service manual?
Have you checked in the paper tray settings to see if someone has set the size to A3 manually ? I don't know if that's possible, but I would check that first.
If you have the manual : why are you looking up color registration problems instead of looking up sc 285-00 ? Looking up the sc code will give you much more specific causes and solutions.
I've only worked on a couple of these and it is a completely different beast if you've only worked on the C5502s. It is a " light " production model that should have come with a Fiery controller (...
I only work with the classic screens, but I know you can do it from the new scanner screens also. From the classic scanner screen Press [Send File Type / Name] and you can choose multi page tiff and...
You are entirely correct. I must have fat fingered 001 instead of 011. I hope no one followed that post. 001 is a very last resort. Thanks for correcting my mistake.