Have the foam rollers been removed from the exit/delivery unit during set up ?
Type: Posts; User: michaelc
Have the foam rollers been removed from the exit/delivery unit during set up ?
When we refurb these fuser units its the inlet guide is replaced as they get in a bad state.
Could always take it out and clean it first to
Always wondered if that would work.
There is a new mod getting tested on the sensors which cause the code. It uses the pressure rollers for the reference as some one has said. There is a little piece of plastic which is fitted over the...
Please dont bend this plate, make things a lot worse.
Just my 2 pence (im english) a lot of people dont clean the dev filters on the black and white machines.
If its high volume you can sometimes get to stage where the guides can loose the curvature...
Before you replace the fuser or put it back on the machine after a rebuild (or even take it out of the machine) you should (dont' quote me on this exactly) reboot the machine without the fuser in...
I wish everyone did this, i just tend to use the customers paper. New machines have 61-11 to compensate for the laser.
We carry car stock so i can be out in the field without stocking up for as long as possible. Parts are logged to the call and if its a which i have on my template it will be automatically replenished...
are you using first of all genuine sharp kit. Are you using the MX310MK or MX510MK kits?
Thanks for posting the fix. Will keep it in mind.
5665165212
This has happened to me once. Would check for a unicorn in the ADF.
It happens on a few sharps. I keep an image of each SD on my laptop for this. Happy you fixed.
Expensive fix, but it worked
Is the laser working?
Sharp fuser units are not that bad. They are all the same give or take (lamps, webs, etc).
I see a lot of people people changing whole fuser units because they are so cheap.
I still try to educate end users, although after more than ten years of doing it I am hoping just once that one person will take notice as it feels like I would have more luck with making a cup of...
These finishers have been used for a while, was usually the cam white with a blue one way bearing in which failed.
Is the mag roller the smooth or ridged?
Do the maintenance and reset the codes for it
Format the hard drive and update the firmware
Are you using genuine sharp toner cartridges? Just to get that awkward question out of the way
I wonder if some one has messed around with some settings and then put them back? Hope this one is an easy fix. Let us know how it goes