The lid(p31) pivots front and rear.the rear pivot can get bent.this may be your problem..
Type: Posts; User: ikon01
The lid(p31) pivots front and rear.the rear pivot can get bent.this may be your problem..
try cleaning ps11 Waste toner container absent sensor.
situated above the waste bottle.the waste bottle moves the flag that actions this sensor.
TECKAT gets my vote!!
have you cleaned the salt sensors? your itb may be worn.
charm is right,if your rollers have flats then swop them out.they will give you all sorts of problems.there is a secondary counter for the ufr under counter>misc>FX-UP-RL.
like you say,it's possible your dev assy has a fault but post some eg's of your issue.it's easier for people to help you.also what's the click on the machine?have you tried emptying the dev assy and...
what was the error code?was it e020 0081 if so id be trying the drum..have you tried stopping copies at various stages and checking the image on the drum-itb-paper etc?
ha ha got to agree,when i did the course the trainer told us of known faults and i did wonder what on earth i was in for.I used to remove those itb assy's on a weekly basis for one reason or another!
SIX screws hold the itb assy in.one at rear frame by the drive gear.one at front frame by where you unscrew the cleaning assy(well hidden,you poke your screwdriver through the front frame) and four...
ah,i think you have just answered your own question!! my best suggestion is to try a4R orientation..
never said that,but i'd be checking to see if anyone has adjusted it.check the settings with the print which should be in the front door.do you know the history of the machine?whats the click on the...
looks like over charge,i'd check the charge and bias adjustments in service mode to see if anyone has played with them previously.do you run oem toner in the machine?also was the drum you took out...
usually worn fuser rollers,bearings and bushes cause the problem.whats already been tried?whats the click on the machine?
agreed,using the sst is second nature to most techs but i really wouldn't know where to start on explaining it to a novice from scratch.
fc5-0343-000 and fc5-0344-000 are the tension arms i'm thinking of.to correct my earlier post tension roller not transfer roller..sorry!!
is it the same for all colours? if so i'd go for one of the the arms which secure the transfer roller within the itb assy.they break on a regular basis.
agreed,great machine but an over priced unserviceable fuser!
I'm an ex Ikon tech working on canon kit for 12 years and 20 in the industry.We were taken over by Ricoh and for the last two years i've looking after the canons with little tech support.I can...
are you a tech?do you know have to load the firmware if it was sent?do you have sst,a parallel or cross over cable?
you said you had replaced the hdd.was it new?was it a canon part?
loud noise from hdd doen't sound right to me!
yeah just checked mine,you need v16 + to be able to format the newer canon hard drives..
charm is spot on,canon change their hdd supplier a couple of years ago.if you can't update the ift file.obtain the latest hd format firmware for sst.i think its v13
FM3-3653-000 fixing film assy
E000004-0202
When the difference in temperature between the center and front of thefixing belt is higher than the rating.
Remedy
Replace the fixing belt unit. Replace the DC controller PCB 2...
is the drum turning?there is a gear screwed to the drum drive shaft at rear frame.i've had the screws snap twice causing this error.may be worth checking!