The toner pumps do cause issues on these models, mainly due to clutch problems, sometimes if you flush between the clutch plates with IPA and allow to dry, the pump can be refitted with no problem...
Type: Posts; User: jivedancer
The toner pumps do cause issues on these models, mainly due to clutch problems, sometimes if you flush between the clutch plates with IPA and allow to dry, the pump can be refitted with no problem...
Polygon mirror motor usually accompanied with a loud screech prior to failure the air bearing breaks down
Possible cause the female connector for the fuser on the chassis, grease the shoulder screws that are within the springs that screw the socket to the frame stops the springs binding on the screws,...
The default toner remaining setting was If my memory is right is 25mg this makes the message seem to last an age reduce it to 5mg before toner near end appears even at this setting there is...
Common problem I have found on this issue the springs in the original machine are too weak and doubling the springs IE fit another spring on top of the other cures the problem this is unofficial mod,...
The statement is correct from teebee have you considered using usb as a a means of connecting and printing if it is just the laptop connected
I have found that if you scan to folder use the Ip address not the server name in setting up the Scan to folder on the Mac
Polygon motor noise is due to the air bearing failing replace the polygon motor
Broken cable bias terminal within the ITB unit causes issues with yellow transfer usually no yellow
This message appears in non genuine toner is fitted having said that I have had it with genuine ricoh toner this is because the small pcb on the end of the Ricoh genuine toner records the usage and...
Interesting if the pipes are empty or are the blocked ie full then in all probabilty it is the pump clutch that is the issue here. remove the pump flush the clutch out with IPA and does this cure the...
First of all you don't say if it is all colours or just the yellow is the transfer producing a banding effect ok then poor several times say over a A3 copy
This problem is in all probabilty the lug that the solenoid pushes against is broken off from the junction gate. replace the junction gate the lug is at the front end of the Junction gate. The cause...
The door switches are more likely to be the issue here when the door is closed the bracket supporting the door switch moves as well. The best solution is to place something behind the bracket so that...
The guys are right change the bearings all four of them