All,
Working on Kyocera KM5035 Locking up after an a hour or so of non use. Blinking Green print light, power save button not responding. Not printing. Fine after reboot. Low power mode set to 240...
Type: Posts; User: Valeo175
All,
Working on Kyocera KM5035 Locking up after an a hour or so of non use. Blinking Green print light, power save button not responding. Not printing. Fine after reboot. Low power mode set to 240...
All,
do I just load the kyocera file utility like I do with the other kyoceras?
Thanks in Advance
ALL,
I am trying to scan to folder from a CS-1820. I enter in the host name and folder scan path and then Save. There does not seem to be anywhere to enter in credentials for authentication. When...
Fax
03.00.00
B2135932E
System/Copy
1.39
...
I am having issues scanning to folder. This is a Windows 7 machine I am scanning to. If I enter Windows Credentials in the address book section for smb I get a "transmission has failed" Message. If I...
Where is that in the menu...I was unable to locate that settings. It is not within the clock settings
All,
I have an estudio 280 that is scanning an hour later than what the time is set to on the machine. Does anyone know what might cause this? I have the time on the machine adjusted to the...
Can someone please tell me how to setup scan to email? I have all of the information in and the I am getting messages on the machine that destination update list fail to update.
Thanks
Can anyone directly me to the scan to network configuation setup info? I have looked for but I have not been successful finding that information.
I have now setup dns. How do I setup up the scan to email so that it will send using ssl?
THANK YOU to everyone that has been helping. I really appreciate. The printer is now printing. Now...Scan to email. I have configured the smtp server and the user info. I am not getting the message....
Ok I was able to configure the printer. It has been found on the network. I used the KM universal print driver. I am able to see it on the network. I am able to ping it. Unfortunately It is not...
ok does anyone know the default password for setup?
Thank you I will try that tomorrow. Also shouldn't I be able to access this via IE? I am not able to. I plugged the network cable into the machine bypassing the fiery. I picked up a local IP was...
there is a fiery
Found option board status its under system 2. However the options under. there do not allow me to change to a zero. Here are the options: fax(main) the options are set and unset then fax sub set and...
there is no option board status in service mode
It will not allow me to connect to it already tried it. There are two NIC's on it. Does the NIC toward the bottom go to the scanner? Does the NIC toward the top go to the network connection?
How do I perform a data clear? Sorry to be such a newb!
Hit the stop 0-0 stop 0 -1
Thanks Will do! I am assuming that the firmware is on the Konica/Minota site. Correct?
I have a bizhub c351 that will not allow me to switch from dhcp to static. The manual button is not listed in the tcp/ip menu. Any ideas? I do have network connection. On DHCP its pulling a...