Search:

Hello

I need firmware for xerox b1025

hope anyone can help

hello
I need some help
I have this xerox b1025 when i try to copy that gives this message "system resource not ready or busy" and i have to unplug it in order to start working again.
I have...

it does not have fan

Hello
I have this Brother MFC 6710 dw
It gives this message often "room temparuture is to high".
The printer gives this message once in a 3 or 4 days

If you try to change country code and language this will happens brother charges 40 euro for language change.

did you check the developer clutch,I had a similar problem some times ago

is to old to make copies

check the fuser unit

The problem was the toner switch it seems good but did not close the circuit so used a jumper and put it out of work.
Thanks

Hello
I have to repair a toshiba estudio 720 I replaced some of the developer gears,and had to clean the new toner transport sectionbecause of cf70 error
after doing this the machine give this...

why are you hiring only Ricoh/ Gestetner technicians

Hi
I made the sensor test and got error.
The display message is something A1 B0 C0 etc I don`t understand.
A 0 stands for sensor (A) and 0 no detection?
Does this message indicate the faulty...

Hi
I have a HP CM6030MFP with this error code 13.20.00 jam at right door.
I have checked for pieces of paper and cleaned the sensors, fuser sensor trays sensor door sensors and still got the same...

I had to replace a separation roller on toshiba estudio 352, I did not had that roller at the time so I had to fix the machine at least for 2 days
until I had the original sep. roller.So I tried a...

Hello
I have a toshiba estudio 166 with ADF, when copying with ADF the copy's come white,the original size is not detected right
if I put an A4 it is recognized as an A4-R.
The exposure lamp is...

Have you tried to cleaning original detect sensors some times dust blocks them and the machine recognizes originals wrong

Finally I got it fixed a few days ago, the problem was at the power supply board F5 fuse was blown and the
paper feed motors did not get any current,I replaced the F5 fuse then it worked paper ...

No the developer is not spilling I/O seems OK.
I think the problem is with LGC board but not sure about it.
I don`t have the LGC board to replace it, thought if any one had this problem before so I...

All trays do not work try-up motor don`t lift the paper in the castes the problem is that they worked all of them
then they stop all at same time the motors don`t rotate.
The copier does not have...

Hello to everyone.
I have a bizarre problem with toshiba estudio 550, does not recognize the paper.
The LCF drawer has paper on it but does not push it up to the feed rollers,this happens to the...

try formatting HDD 0-8 690

The toner in cartridges seems to good, I thought if there is any way to raise density of toner, I think to use it for a while before replacing cartridges.
Thanks

I have a HP cm6030 mfp which was not used for a long time.
Now is back to work the black copies are fine,the color copies are very poor except blue,I tried raise the tone in admin menu still the...

Thanks for the reply
I have all ready checked them seems to be OK the drum is practically new I changed it 1 month ago it have done 6000 or 7000 copies
I found one other part that seemed not to...

hello
I replaced developer on toshiba estudio 161 with a new genuine developer resets the developer counter
the machine worked perfectly for about a 1 month 6000 copies then it start to waste the...