Battery of the NVRAM on MFP Board empty. Needs new MFP board.
Type: Posts; User: HoonBoy
Battery of the NVRAM on MFP Board empty. Needs new MFP board.
Little late reply, missed ealier notification... We had this problem on 3 different machines in one week time , my guess is that the weather had a big impact.
Had this once before and replaced all...
Could not get in the firmware update after the first MFP controller N.G. Only black screen after that.
You can always swap the caps from a 4/8 serie toner with a i series toner. Just reset the toner with engine switch, no chips needed.
Had to do this a few times in the time that Konica Minolta had...
More often it happens that an update does not work, often USB-stick related(reformat and write firmware again.
But never before we had an CPU-board or any other part got defective after an update...
With nothing I mean nothing helped, only black screen with any of the tried options, only replacing CPU-board helped.
Hi all,
just wanted to share some "fun"
I a week time we had 3 machines that "died" on us after updating them to version AA2J0Y0-F000-G00-Q9.
What happend is that during the firmware update...
Did any of you get any instructions / procedures to update the storage firmware of a Phison 64-layer SSD (AA2J0Y0-6501-G01-07 -> AA2J0Y0-6501-G01-08)?
I only recently found out that you have to...
Hi, we had a few of these cases in a short while as well. Everytime the drum life is still about 50% as well and drums all look fine. First time we replaced all drums(CMYK) as well.
We did find a...
I guess you will need to replace the CPU Board.
Thank you, I was going through the all solutions documents and in it, it refers to the TSG, have these for old models but not for the I series. Was hoping you had these too. Thanks anyway for this...
Great work, many thanks. Could the Troubleshooting Guides From the latest I serie machines be shared as well? Thank you!
The original "Chip" is just an resistor and a fuse. I soldered a push button with wires on an old "chip" to reset these kind of IU's. After reset just put back the old chip.
Maybe you can reuse the...
mind sharing the tool and hdd partition instructions? Would be nice to save an SSD.
Mind sharing the release notes?
I was told that this could be caused by bad spring contact on the HV... Did not solve my problem, had to replace 2 IU's
Attached document is added in the box of new machines. Instructions to shake...
I’m more curious how you resolved the TPM error?... Had this together with “black only” and fax error(no fax) after empty Battery on MFP Board... Replaced Battery and tried MFP reset procedure few...
You can login with other region account and use the US Marketplace: MarketPlace
If the ADF itself is adjusted and it's still skew then you can adjust the pressure of the white rollers in cover. Open pickup cover and loosen screw on front the adjust pressure.
on C458-C558-C658 series AirPrint needs to be activated with a license... Got one general for all machines...
Someone playing with remote panel?... Turn it off and change password... Then the joke is on him...
If i recall correctly, you can only format SSD if HDD is set too "not installed". SSD format is availible where format HDD was...
The fusingunit for this printer as for the C3110 and C3850 series ar modified for this problem. There is an uneven pressure in fuser. Other (more thick) paper usually does not have this problem...
Looks like the 1st transfer rollers CMY don't come on pressure, could be a problem with the 1st transfer pressure clutch (CL5)...
Had this kind of problem in the past with a C253 series machine
I just tested a machine with GD1-K5 firmware and it did not have this problem...