Is there a national company like handy pros that offers up tech jobs In your local, that you grab and then service ?
or even a National company that subs out it’s work?
Type: Posts; User: dhg
Is there a national company like handy pros that offers up tech jobs In your local, that you grab and then service ?
or even a National company that subs out it’s work?
cleaning blade streak issues on these kind of look wavy and come and go, not typical of other machines . Also change mc wire and vac drum assy.
look at the bulletin Number ( 030 ) under the mpc3003 D146, sounds like similar issue. There are some bit switches relating to toner that may need to be changed.
It was the bottle motor failing intermittently !
hopper did not fix
Thank you !
Machine In non-production environment, total meter is around 100K.
i vacuumed out hopper prior to swapping sensor and motor.
oem ricoh toner...
thanks again
i have tried 2 new oem cartridges, swapped peizo sensor and motor.
has anyone has this issue on this model ?
Ricoh said replace hopper so i ordered on
thanks dg
how do i adjust sensitivity on this smart panel, since C1993 went away ?
thanks
Actually right after I posted this I got another C–a 101 controller not starting.
Started with a C-A 101 code start up error.
rebooted and now tray 3 lct not showing up.
tried PCRB.
OACB ?
LCT BOARD ?
Anyone seen this, thanks in advance dg
Trying to get an idea of how many calls a day is normal for production color tech on average ?
Thank you !
Mike
Yes i over looked the worn side of the pre reg roller on one side, lighting or angle was bad... Excuses excuses !!
It was damn obvious after i removed, i'm a dumb fuu...
i' m more of a copier...
It's fixed , pre registration roller assy ....
thank you all for help !!!
it does it from any type of print,not every time but every 2 to 4 copies, the trays guides are tight...
It is on printed image, so seems like registration area or prior, vertical
skewing from both trays 2 and 3. i have eliminated toner cartridge, actual trays, paper types, cleaned vertical guides reg rollers and checked for build up or foreign objects. 450k ideas ?
i have read the discussions and it seems this is the doomsday code...
i have change every board in the machine and still nothing
any advice? thanks, dave
can anyone tell me where to find this firmware on the km tech site? it is supposed to be the firmware to turn off IU message so u dont need chips or new iu's...
A00J0Y0-F000-GPA-R6
not finding it...
Yes i did all the set ups after PM, fuser is clean,square cl clutch appears to be working,no build up b4 or after pm in that cl auger....
there appears a dusty drum if you dont point flash light...
New dev, drum blade seal roller wires etc...
if you run 30 or more you turn ream on side and dirty edges
appears to have dev unit ground tabs etc
any ideas, is there a firmware update for this??...
Sep jam, i finally got it to jam on 1 copy and the paper was at exit but machine indicated exit and reg roller remove... Its got to be that switch, i replaced the timing motor coupler
OK so
sep jam is under drum from everyone's feed back so i changed t/s wires, cleaned timing roller and puffed out sensors. fuser is in good shape.
the paper just stops ,no fold curl or accordian...
basically it just stops no accordion or drum wrap.
after cleaning i suspected that switch above fuser on frame , thats why i wanted to know where separator jam is, because its always there in the...
DUmb question but been a few years...
It registers separator jams, is separator refering to corona separation or fuser separator.
any incite before i dig further ?? ive cleaned entire exit side...
kyocera, konica, ricoh fam, sharp muratec