Are the fusers warming up?
Any paper stuck behind any drawers?
Any recent error codes logged in service mode other than the E720?
Check all 3 Front Door Interlocks.
Also check the staple...
Type: Posts; User: its_just_a_copier
Are the fusers warming up?
Any paper stuck behind any drawers?
Any recent error codes logged in service mode other than the E720?
Check all 3 Front Door Interlocks.
Also check the staple...
This is part of your lower Fixing Belt Assy. If you are going to change this, yes you should have the Service Manual handy because you have to dig into the Fixing Assy to do it. Too many steps to...
Yup, I've seen the H1 regain connection after doing this. If that doesnt work you may have to reload the H1 system software.
Does that cable guide help at all? It looks as if they just added a shelf to keep the toner from falling onto the sensors and board below... My problem is if they knew the toner dropping was an...
SP5875 Auto Reboot Setting
Set to 1
SC899 has been mentioned quite a lot in the firmware updates so make sure its up to date.
Also format your HDD SP5832-001. This has fixed many SC899s (Before doing this make sure your address book...
KILL 15 ?
that board looks like it went through a fire or something...where is it in the Imagepress?
quizas no era compatible disco duro?
era de Canon o que?
cual es el numero?
FK2-7429-000
1
Claro, este firmware es IR5070/IR5570/IR6570 solamente!
https://dl.dropboxusercontent.com/u/20401763/iR5570_6570_sys_v42.01_.zip
Feliz Navidad =)
Son distintos seņor.
Most likely you are running the machine out of spec.
Check COPIER>DISPLAY>DPOT>VFF if your value for M is higher than all the other colors (400+) you have a bad LASER FM2-4887-000.
(normal range is 200 ~ 300)
Some have been successful in...
OK...
Open your front door, remove the inner cover. You should find some pink papers, these are your factory service mode values. Check everything and make sure your service mode values match.
...
Is your Cyan drum coated with toner? If so replace it...
Well since your PG10 and AutoGradation sheets are washed out you can forget about any CCD settings... that's just off the glass.
What are your drum lives showing? Have you cleaned all the...
First of all, what model Canon are you working on?
Second, Have you printed the PG10 from Service Mode to see if it is also washed out?
Are you using a Postscript or PCL driver?
Either way look to update the driver from Canon's site www.canonusa.com.
Does your machine have a ImagePASS?
If so has it been calibrated?
Error :
For various error codes and malfunctions. If you suspect that the Finisher Controller PCB may need to be replaced, try the following to reset and clear the memory of the Finisher...
Could also have a short to one of your thermistors in your Fixing Assy.... seen them shut the machine down before with no error code whatsoever.
That's a driver issue. Your customer is printing a process black, and the driver can't raster it properly.
Change the driver. :D
Any blade can leave wavy lines, the reason they do this is to prevent premature wear & tear.
At this point you should remove each drum and transfer belt unit to see if these lines appear on the...
I've noticed those big screws that hold the hooks loosen up over time.
FM2-9766-000 Thermistor Ass'y THM1 & THM3
FM2-4161-000 Thermistor, Sub THM2
:cool: