Ive been back and changed the CPUB board and the storage board but still have exactly the same issue,
Im leaning towards a DCPU issue but ive never had one go before so still a bit reluctant to...
Type: Posts; User: Gaffers01
Ive been back and changed the CPUB board and the storage board but still have exactly the same issue,
Im leaning towards a DCPU issue but ive never had one go before so still a bit reluctant to...
Hi,
I have a C257i that keeps powering off and the only way to power it back on is unplug machine and it will come back on and work fine.
I've updated Firmware to latest available even powered...
Id replace the 2 rollers that are touching each other they look pretty worn (they should look like the roller on its own)
This is the easiest point to start with any fault finding with jamming.
If it jams but no paper being feed, its usually the bottom of the 3 rollers (separation roller).
Also just check that the paper is loaded properly as you will also get this issue if there is a...
Try a double sided copy through the dadf to see if the second side is the same.
What about scanning? does that look the same
Are you an engineer?
Did you do the work on the machine?
It looks like there is no pressure between the fuser rollers which is why the sides of the image look fine.
Impose has a license, so maybe an issue with the licensing.
Hi,
Does anyone have a service manual for the Toshiba E-studio 5015ac, im doing a call for third party and haven't looked at a Tosh for a few years. :confused:
Need to do "Special Altboot"
Can you attach a photo that is bigger ?
Ok machine is now working :cool:
But is still a weird one :confused:
I went back to the customers to have another look and managed to get a copy through all different trays by choosing colour...
I have a Altalink C8070 that is jamming EVERY copy from tray 1 - 2 and MSI but tray 3 and 4 both work no problem.
The paper stops folded with no image on it before the ITB (quite difficult to see...
As the title says Im working on a Altalink C8070 on the latest firmware 103.003.023.22910
where there is no magenta on anything copied or printed including test prints.
I replaced Drum R3,...
Have you tried a different file format when scanning ?
Make sure NVM 711-188 is set to 2 and restart machine
Did you swap the SSD over from the Lightning strike machine?
Lightning strike could of potentially killed everything in the machine, including wiring loom, control panel.
Have you tried to install Firmware as you said there is now power?
I would recommend getting a trained service engineer to have a look, you could do more harm than good taking the back of the machine apart.
The 2nd image looks like its the cyan drum unit that is causing the lines, replace the cyan drum.
Haven't worked on one for a while, but i remember having a few issues with the IDCS assy which would be have to be replaced.
Also could be Transfer belt or drum what do they physically look like?
What is the main difference with the DR620K and DR620?
Can the DR620 be used as a K drum unit.
Also can the Du106 and Du105 be used in this machine, I know the end needs to be changed to fit in....
Hi does anyone know how to reset the admin password on this device?
The customers IT man set the machine up and has since left and we have been asked to set the machine up to scan but I cant get...
It sounds like is a formatting issue, going from memory when you print an adobe pdf it gives you an option to "print as image" under advanced.
See if that helps as it should then not format it.