This morning I tried cleaning. Octagonal glass in the Laser Unit, the result appears that the machine is working normally. for unknown reasons But luckily nothing was damaged.
Type: Posts; User: satitjangdee
This morning I tried cleaning. Octagonal glass in the Laser Unit, the result appears that the machine is working normally. for unknown reasons But luckily nothing was damaged.
Machine on OK. When make copy scan unit work fine but paper out is blank. On panel shows "wait to print" and nothing do on machine.
I check corona wire all blocks are good condition, pin not broken,...
OK solved. Cause by Developer assembly< high volt cannot supply.
Yes, after polishing the drum I remove all of the polishing compound with dry cloth. Before this I Cleaned 3 DRUM of my machine. I see alarm code it show 320002.
please help.
after making DRUM cleaning copy output is OK but left for along time copy is blur all middle page.
post closed. DC controller.
I test again on another machine. Boot up OK but after run about 30 copies so code comes.
By the post first I change new fan, code come.
after that, DC controller moved to another machine, it work OK on that.
I think fan OK and DC controller OK too.
:confused:
I changed FM4 fan from ir5075 (I think the same) it get the same code .
I took DC controller from dead machine and insert in another good ir6570, it work OK so DC controller is good.
I went back to...
Thank so much.
You great.
If I take off LAN Card (don,t need), can solve this problem?
Thank you so much.
So, do these series use the same system software as 5020i?
I had buy HDD with ir 5020i system software installed, it get code 355-002.
But when I changed to another HDD that...
I get as below.
27428
I don't know main controller board #FG6-5979 is which model?
Who know, please.:confused:
thank a lot.
I must reload the right system software.
Hi guru.
I have checked my copier, it model ir5000.
So, can I use system software of ir5020i for ir5000?
And Error code E0355-002 is occur because of this non match system software.
So thank for Teckat with detail to solve my machine fault.
But first I must check my machine which it is 5020i or not because it not look like another ir5020i's shop.
Yes, you may right.
I just notice that my ir5020i is not similar the one that another shop has.
thank you for your quickly reply.
canon IR5020i get code 355-001 after replace HD with a new one (system software installed).
Who know this code mean?
No this code in error code list.
Thank you to everyone for useful info.
This site has many friendly friend. :rolleyes::rolleyes::rolleyes:
Thank a lot! :rolleyes: I will find it.
The error code point to Harddisk fault but the machine no harddisk. How to solve.
First, screen come up with the error code. I look for H/D but non, so I reseat 2 DIMM at the DC controller and main...
I had this problem in the same model.
My issue was the gap between the metal plates before entrance the fixing tray. It was not enough space for paper to pass.
I solved it by increase this space....
I live in Roi-Et province, Thailand.
I don't know the shipping cost.
Sorry what PM do you mean?
IR 5075 not the same part as IR 5000