Search:

PS unit most likely There is a spring at the rear that keeps the pressure on between the rollers. The plastice will break where the spring hooks on.

If the machine has DSK you wont get 24-30. I believe their is a dip switch on mfp to reset.

Also may want to try a SD card or the HDD

We had one giving the code for cyan. We replaced the the Home position sensor located in the back on main drive. Once we got it out we found it had gotten the clear grease in it from the gears.
Must...

Had the same thing the electrician wire it with only one leg of 110. The issue was smearing on 20 lb paper. The other thing is the sharp surge gave us a green light.

sharp knows of this issue both the ones from NPC and sales has this problem.

Have a machine that does self prints and copies from the feeder just fine, When coping from the glass the image is very faint almost blank. I have tried the background adjustment with no help. Not...

You may want to calibrate the CCD first using a SIT chart or using Sim 63-05.

You may want to look at the DV unit. They did change the doctor blade.

Was wondering if anybody else is having issues with the msata cards on these new style machines. Also has anybody found a way to reprogram or get them from a secondary source and program them. Thanks...

check under paper tray settings to see if at least one tray is enabled for faxes.

Look at the drive gear on the back of Transfer belt unit. The other might be a LSU. Posting a sample of the image quality might help to determine the issue.

Sharp has taken away the ability to program the counts. Did you transfer over the EEPROM chip from old PWB to new one,for that is where the counts are stored

Since internal prints look good It would be a optical problem, Try scanning to PC or do a preview and see if it showa up there.

What is the jam code?

There is also a TB that will change how much and how often the web advances. Good luck

All OEM supplies, the other end of drum has very little build up. By the time the drum got to this point there is toner everywhere at that end the end of the MC is filthy.

Reset sim 24-4 and 24-5 and running 25-2 if DV changed

The machines are not pulling DV. I talked to Sharp and they said there are no reports of this

Main charge was replaced the same time as drum. This is about the 3rd or fouth time it has happened on this machine. It occurs about every 70k. Its is not the only machine we have doing this

I was wondering if anybody else is seeing the issue of toner building up on the end of the drums. It looks like it gets baked on. We have replaced the drum units, DV units and drums and it still...

So what are the customers thoughts when you run 250 sky shots?

What I was told was that they were going to have the DSS's teach the classes. But I would think they would have the on demand classes listed.

You can use a good SD card and copy over to the bad one. Only place to get a new one that is programed is from Sharp

Sounds like corrupt firmware. Try to do emergency update