59175
Type: Posts; User: jon jennings
59175
I don't think you will need firmware. The new machines backup all the info needed and will write what it needs to the new drive.
Very inexpensive part can drive you nuts. PSHEZ5449FCZ2 there are 2 of them and they can get paper cuts in them causing jams.
MFP surface mount fuse could be blown. We just replaced an MFP for this symptom.
The "ONLY" way to reset the password on this machine is to take the back off and use the microswitch that was referenced in an earlier post.
The MX C300W has a micro switch on the MFP to reset the password.
I forgot to add running 46-74 after the other commands.
The waste toner container is not inserted all the way and the auger can't get into the waste toner container. Therefor the auger backs up and from friction the toner hardens and takes out the process...
The Orion series have a tendency for process control to run wild. If you clean up the machine then run 44-02 44-27 44-06 and 44-26 in that order it will clear up the problem until it does it again....
You can send the clone with 56-02 also.
That is correct.
Go to another machine (MX 5141) model doesn't matter. Go to Storage backup. Choose User Register Information. Create backup. Go to the MX 5070, type IP address. Go to (IP address...
I have machine that will not make a copy through the document feeder. It says check original. I have replaced all the boards and the document feeder. Any thoughts? I ran all the test commands for the...
Well now that I am Lexmark tech (it says Sharp on the front) I do not know how to get into the diagnostics of these machines. Any help would be appreciated.
Hello, KDR363
I am wonderring if there was a resolution to this problem.
It shows you are a Sharp dealer. Download the manual.
What model are we talking about? The one I have that has a line through it needed a LCD to be replaced. The cost of the LCD was more than a new board.
Check the upper guide on the RB. the hinge will break and cause this trouble.
Go to another machine (MX 5141) model doesn't matter. Go to Storage backup. Choose User Register Information. Create backup. Go to the MX 5070, type IP address. Go to (IP address...
" Go to another machine (MX 5141) model doesn't matter. Go to Storage backup. Choose User Register Information. Create backup. Go to the MX 5070, type IP address. Go to (IP address...
Go to another machine (MX 5141) model doesn't matter. Go to Storage backup. Choose User Register Information. Create backup. Go to the MX 5070, type IP address. Go to (IP address...
You can make a clone from another machine. Say a MX 5141 (model doesn't matter) of just the use information. Go into the service page and send it to the copier. This will reset the admin password.
There is a bulliten to replace faulty sensors on this model. I think it can be as many as 15 sensors.
Go into printer settings and uncheck "print ledger as A3"
Try putting 5 to 7 pieces of paper on top of the image. Also if it is skewed at all from the drawer this will happen.