Hi, All. Hope everyone is having a decent day. I am looking for the part number of the "booklet tray full" sensors on a SR3220. I located the bracket in the parts catalog, but not the sensors...
Type: Posts; User: mikadonovan
Hi, All. Hope everyone is having a decent day. I am looking for the part number of the "booklet tray full" sensors on a SR3220. I located the bracket in the parts catalog, but not the sensors...
Hi, All. Quick question. What is the part number for the transfer belt? I cannot find it in the PC. Do I have to order the whole itb assembly?
Hi, All. I have 2 MP C6004ex sitting side by side at an account. The fusers look good, but there is a little popping noise from that area on both machines. When I tried to run the fuser motor in...
Hi, All. I seem to be having a lot of weird issues with the bypasses on this model. The problem appears to be with the lift plate. Is there a RTB that covers this?
I cleaned the terminals on the back of the Itb assy, then the id sensor
Booted fine, no errors.
Hi, All. I hope everyone is having a good day, as I am not :). I have a SC 440-02 on a C5503. This code is not in my manual. Nor is it on Printycopy's website, which I use for mobile reference.
Does anyone have a point to point diagram for the Ricoh MP C 307 ? It would be greatly appreciated if you could send it to me. mikadonovan@yahoo.com
Never mind, I'm an idiot. The model in question is a mp c307. Thank God.
Anyone ever replace the bypass roller on a MP 501? After reviewing the procedure, it looks like a nightmare. And how long does it take?
Hi, All. I had an IT guy contact me with an issue on setting up a new PC for one of my clients. They have always had managed IT services with another company, but they have changed people. Her PC bit...
Turned out there was no issue with the machine, it was all about her PC.
Hi, All. I have a c5503 that has very inconsistent image quality. Image 1 is how she likes it. She printed that one in the morning. Image 2 was printed later in the day, and is very different . Same...
Make sure you change the blade and cleaning brush, too. Clean the filters. High heat inside the machine will cause overtoning problems.
I figured it out. The bottom of the finisher entrance guide is supposed a locator pin to restrict side to side movement. This one does not.
Hi, All. I have a MP6002 with a SR 4080 finisher attached. I am getting misfeeds with a jam code of 151. Only problem is, there is no jam code 151 listed in the tables. I believe that it has...
C4504ex. I looked at the firmware part numbers, none of them began with the letter C. Ftp and all that stuff is active. Thanks for the responses, I'm not going to worry about.
Hope everyone is having a good day. I have been using the update tool for a while now with no issues. However, I have a machine that the tool will not recognize. I am wondering if there is a setting...
If you have replaced the fuser with a known good one, you will need to try another brand of paper. I have run into substandard paper before that would absolutely not work in any machine.
Hi, All. Can anyone tell me what sp2961 "developer adjust mode" does on this model? The manual does not give a description. Thanks.
Old machine, but I think MP C3300 developer is the same.
It turned out that one of the thermistors I installed was faulty.
Hi, All. I have a sc555 on a 7503 that will not clear. Both thermistors have been replaced, and all thermostats check good. Anybody run into this before?
Check SP 7624-03.
I checked 5828-91, all good there. I did lower the security level to "0" from custom, and rebooted. I was then able to access the WIM from my laptop with a patch cable. It is now in the hands of the...