Are you sure ? as problem is intermediate. after switch off machine for 30min sometime its works fine for a whole day and sometime we need to Switch off many times. we have clean laser scanner many...
Type: Posts; User: aborad
Are you sure ? as problem is intermediate. after switch off machine for 30min sometime its works fine for a whole day and sometime we need to Switch off many times. we have clean laser scanner many...
Thanks for your suggestion. We had clean mirror and motor but problem remain same.
Hi everyone..
One of our customer are using 3nos of Kyocera Taskalfa 4501i machine. since last few days we found intermediate light printing at bottom of page in all three machine. After switch...
yes i am using this software and its very very good. easy to configure. using since last one year. you will have a nice experience.
what to do with faulty main control ?
Hi sir,
Have you find any alternate way to resolve this problem.I have replaced almost 6 number of Main Controller and it cost me a lot.
Thank you so much..
Hi..
Is this possible to share that tech bulletin ?
Main PWB - operation panel PWB communication error.try to reload firmware..
Sorry for typing mistake..... for KM-3140 firmware is S2LX_2F00009002 and for KM-3140+ it is S2MG_2F00007003.. just for your information.
Finally found firmware to resolve this issue..there is a technical bulletin from Kyocera and firmware version is S2MG_2F00007003.
Unzip all the fine and put it in a root of Pendrive or CF Card.. but insure that no other file should be there..
check the DP cable.. i have same problem..(77 303LJ46010 CONN. CORD ASSY INTERFACE)
Check cables which is connected to Control Penal to Main board. i mean continuity.
Thanks for your reply ,I will check and update the status...
Hi,
In KM-3050 intermittent error code C3310 showing. as per manuals its related to CIS AGC Problem. we have replaced DP Main PWB. but problem still there.
also we have replaced DP inverter PWB....
Nothing worked... Finally I have replaced main logic card.. and its working OK now.
Thanks for Reply.. i will update last Status.
But problem is that even I print 3 pages but printer is count 4 pages. so its increasing total Page count.
Hi.. I have make Duplex Enable in Driver setting... when I print 5 Pages first 2 pages print in duplex but last page I don't want that paper again goes in side printer and then print.. last page...
i am interested in PU-102 (1) Process Unit please mail me on ashish@avtechnology.co.in
I have latest firmware if you need..ashish@avtechnology.co.in
tell me sequence of led blinking so that i came to know the problem. if last led(RED) is blink twice then printer is adding toner in to developer and it will take around 20 min. so keep printer on.
Error is related to Main board and i just want to know that is there any option like init. all Memory. or init back up memory.. I am going to update Firmware , I will tell you once i done it..
I can help you... send me mail on ashish@avtechnology.co.in