Also run 44-2, it will show the sensor that has a issue(will get err message)
Type: Posts; User: Sharptech0892
Also run 44-2, it will show the sensor that has a issue(will get err message)
Thanks for the replies.
Hey guys, I have a few 6580 in the 2mill range. I'm seeing a lot of pdppd2 and fed jams, seems to dog ear the front lead edge corner also, we've had several techs look at them and can't seem to...
Has anyone had intermittent jams at appd2 not being reached? So far we’ve tried the duplex motor and interface board on the right door. Planning on replacing flag sensor arms / springs next. Any...
Just curious, are you updating the firmware after all the options are installed?
I was wrong, thinking of a different code, f1-22 is referring to the assist motor, which pushes the paper out onto tray after being stacked or stapled. Fnm5 motor
What I found was two gears that drive it don’t mesh together (to much gap) I was able to bend the shaft the gear is on, which fixed the error code.
MSata has seemed to resolve issue, thanks for the replies.
Went back today and noticed it locking up/rebooting just sitting there, ordered a mSata for it, will update findings.
mike
I have a intermittent problem where copier will turn off(reboots) during print jobs, I have yet to see it happen on site, problem started in February, customer stated it locks up prior to turning...
Unfortunately there’s not, all new sharp are that way, best thing to do is reset if have any service calls prior to it being due, and reset early.
Hi, I'm newly trained and trying to figure out sp modes for test prints, is there a sp for doing solid single color print for each color? Or any good test patterns to use when troubleshooting cq...
Replaced the main charge black box assembly that mc hv unit connects to the contact points, fixed issue.
Lines go front to rear not lead to trail, image now looks like what you get with dirty main charge, see example
Replaced entire itb same result.
Have a mx6070 getting intermittent cyan vertical lines when printing and copying in color. See attached file, have tried drum,mk,dv unit, primary hv pwb, no luck so far.
We have had several fn20 finishers when doing a saddle staple job, 1 page is sticking out more than the others, any tips on a permanent fix? We've tried cleaning the rollers, replacing the half moon...
Replacing primary belt and blade fixed it.
Can't seem to resolve a error when calibrating a mx-7500, when i do t.c 44-2 I get a error on reg_r grnd, tried a different image density unit, density on each color looks great, any ideas? Bad...
Disregard, problem came back!
The one sheet being feed is to prime stapler, do both sides staple when priming? If one is not that could be the cause for jam.
We had an Fn 22 with the trimmer option on a MX 6500, problem we had was it would randomly not trim a page, fix was replacing 0cwfm402980// wiring harness that goes from trimmer pwb to finisher pwb, ...
Resolved, replaced paper guide in paper staging area before its stapled and fold fixed issue.
Dirty sensors on either black or color on primary position, test with tc 30-1 1 tud cl and k should change state when turning belt cam by hand.
I have a fn29 finisher that
intermittently doesn't stack all the pages evenly when saddle stitching booklets, one page will be sticking out when folded, tried replacing all foam rollers with no...