I have Xerox 5790 with message TONER CONTROL SYSTEM FAULT I checked my Dev tank the gears are seized due to toner clotting. I replaced gears and un clog the dry toner and now its turning fine. The...
Type: Posts; User: MWALA
I have Xerox 5790 with message TONER CONTROL SYSTEM FAULT I checked my Dev tank the gears are seized due to toner clotting. I replaced gears and un clog the dry toner and now its turning fine. The...
check when you open the tray select desired paper size from the paper size selection wheel
i have a cp 1215 which isnt producing correct colours. Is there any service adjustments to this. i changed catridges but still colour mismatches
The machine is also cutting words at the bottom. Pls help
I just had a brand new canon IR2525. I want to add toner in the dev tank. What is the service mode proceadure
Thanks a lot
the problem still the same
"the appropriate A4 size is not available"
This is a new machine with 1220 copies. Each time you make a copy on auto paper select it selects A3 and call for wrong paper size. Even if you select A4 it says wrong paper selected.How do i make A4...
Im getting error code E21yyyyyyyyyyyyyyyyyyyyy on toshiba e-212. Is there a way to reset it. It is about the scanner but what exactly
Pls help
Misheck
After i cleaned the laser unit after very bad copies when using the document platen glass an error code 52.00 appeared, followed by 51.21 all pointing to the laser unit. All I did was cleaning. How...
I tried another imaging unit but the same problem
I have aficio 1015 with ghost imaging. I replaced the heat roller, heater lamp thermistor and pressure roller but the problem wont go. Its affecting the top side and the bottom side. What is the...
Fuser Film error,
If fuser film is intact, clean the white patch on the film usually it gets dirty and wont be read by the sensor
I've got IR 5000 and if they are the same whats your offer. I'm in Zimbabwe.
How do i change display language on canon ir 4025i Advance
this is how my inverter board looks like. Please check C8 and C9. can you advise if something is wrong there.Arent there supposed to be 2 blue capacotors.
...
I mean the display panel was never opened
In this case the machine has done 155k copies and it was never opened
I have a canon ir 3235 with a display panel thats dark one side than the other.
if you try to lighten it wont be bright enough.
how do i solve this problem.
I have a toshiba e-studio 3520c showing error code ce-70 and the paper stops at the reistration rollers
anyone with solution to this
I have a canon 3235 which when i select the stapling option it shows a message 'Load Staples' no error code even if staples are loaded. I have a similar machine that i was using to swap units i.e...
Thanks guys for your suggested solution. Actually the 12 pin connector was half connected. After securing the connector it really solved the problem.
But guys I felt let down, mjarbar refered my...
How do you turn on 2sided copying on ir 2022
Try cleaning dev roller with a soft dry clean cloth.Don't remove it. Dont rub too much. As you rub turn the dev roller gear all the way.You shall feel it getting smooth as you rub. Put it back and i...
I erroneously adjusted the fuser film pressure springs on ir 3235 and now when i fit the fuser film its moving on one side tearing the film during the process. Can anyone tell me how to adjust the...
After a series of fuser jams, I ordered a brand new fuser unit. After replacing it still the paper jams as it comes out the unit with the trailing edge crumbled inside the unit,well through the...