Gentlemen thanks' a lot for your help...The mahine is now detecting the finisher, the problem is the connector.
Type: Posts; User: Arcking1968
Gentlemen thanks' a lot for your help...The mahine is now detecting the finisher, the problem is the connector.
Recently we bought a canon IR7095 to replace our old IR 105, but when we attached the finisher the machine can't detect it. can somebody help me how to program it.
Thanks in advance...
I've encountered the same. Twice I replace the developer the third part I replace is the main board. The problem didn't return.
Akitu is right. Once I encountered the same problem I found out a blown fuse in the power supply. Another of our technician also find out the same trouble but the problem is the Triac also in the...
A week ago i formatted a MX-453 using 62-1 it took an hour. Make sure to write the meter reading because upon formatting the meter reading also will reset. Luckily I print the configuration and...
L4-01 refers to lock up motor but check the mechanical there might be a tight DV,DR or fusing unit.
Most probably if you ask the dealer of the spare parts you need for this machine it is expensive than a new machine.
Canon NP means "no parts":)
If you cannot make some remedy to the hole, the best thing you can do is to replace the DV unit.
Welcome:)
Welcome to the club...:o
Try google...
Try to upgrade the firmware...
You've try almost everything, are you sure the parts you've test are all good? Did you test it one by one?and regarding black copy there is a totally black copy, and black copy with an image. Try to...
If I'm not mistaken 44-2 and 44-4 is for drum mark sensor and I.D sensor, try to access the simulation and run this program and then adjust VR1 and 2 to plus minus 200. Usually even OEM consumables...
Welcome...:cool:
Welcome...:cool::cool::cool:
Welcome...:D
Welcome...:D
Welcome...:o:o:o
Shall I say test print?!, or test copy?! Welcome...:cool::cool::cool:
Welcome...:D:D:D
Cheers...;););)
Welcome....:cool::cool::cool:
Maybe the glossy picture paper cannot feed by the roller, try to use the bypass tray...:cool::cool::cool:
You must concentrate on slit glass, or check the ADF guide that the paper is passing thru, maybe there is some dirt or color lines which is reflecting to the image.
I don't think that there is a program or simulation to remove the toner low indicator...