To get into service mode,
Hit "user tools", #, 1,0,7, then the start button (Round green button).
Type: Posts; User: silvia0073
To get into service mode,
Hit "user tools", #, 1,0,7, then the start button (Round green button).
No problem, It shall be shipped it tomorrow (9/14). Thanks!
Dying toner pump? I had an auger in the toner transfer assembly all twisted up once causing similar issues.
Have you checked the SMC and see if there are any service codes logged? I had an issue with a machine where it would go into energy saver and will not print or recieve faxes. It had a few service...
Absolutely, correct! I assumed each tech knows their machines and their history, simply going to another tech's machine and doing forced toner is definately a poor decision. Knowing my machines...
Good to know!
True, but if the customer hardly use color, doing all that would just be a waste as even after all that, a couple energy saver cycles and auto cal cycles, colors are again grainy and washed out. So...
Just dropped the price to $50 per tube.
They are very expensive but I have about 8 tubes for $75 dollars a piece brand new. It's listed on e-bay, here's the link.
Barrierta S 552 R Grease | eBay
For the graininess, try doing a force toner once or twice. That always helps at accounts where they never use color and when they do, the colors are all faded and grainy. As for matching color, you...
PCU is seized up. Replace the PCU and you'll be fine. I have that happen all the time at one of our accounts with like 30 of those machines.
Try replacing the fuser harness, that worked for me. The part number is B2385398. Otherwise, i could be an IO board issue. I'd do the harness first. Good luck!
It's been pretty customary for me to clean out the black pads on the opposite side of the sensors. It's a felt/cloth type deal. I use a can of air and just give it a good blow. There's two spots...
PM me your e-mail, I can send it to ya.