thank you very much.
and resolved to the fault.
Greetings from San Luis Potosi Mexico.
post data.
that way I can make a donation?
I have only debit card.
Type: Posts; User: cibergoose
thank you very much.
and resolved to the fault.
Greetings from San Luis Potosi Mexico.
post data.
that way I can make a donation?
I have only debit card.
thank you very much.
I was a bit difficult to access the registration sensor, but eventually achieve clean, thereby fix the problem
have the J63 jamming and I have no manual, refers to sensor??
Thank you.
check the pins and sockets and found nothing abnormal.Check if connector is broken into but I see they make good contact.I know that means the code E73-ooo1.
thank you very much for the reply.
Ayuda por favor.
me indica codigo e 73-0001 image press c1
no tengo manual
alguna idea se los agredecere.
gracias
Gracias por responder.
Ya probe la dc controller en otra maquina y me hace la misma falla.
Hola buen día.
Tengo una canon ir6570 que solo enciende el led, indicador de equipo encendido. pero no enciende la pantalla táctil. ya realice varias pruebas y mediciones y la conclusión fue; dc...
Aficio MP 2851, copiadora digital de Ricoh
on the website noted above corresponds to the model.
These teams have less than 30000 copies.
mp3025 vs doing a comparison.
is better in the mp3025 copy...
hello
I write from Mexico
I have clear copies on multiple computers even recently installed.
print, fax and scanner works ok.
service mode you can adjust the copy?
Thanks for your attention.
I guess that clears the same way.
ok thanks.
FB4-3687-000 is the number of corona wire I use.
let me tell you though the vast majority of end customers in Mexico will not authorize the change of filter.
thanks for the suggestion.
corona wires are changed from 50000 to 120000 copies.
had previously commented that performance up 400000-500000copies.
the copy quality is poor in copying and printing.
present in equipment...
hello to everyone.
what is the process to clear this message.
Thank you.
I offer an apology if he broke a code of ethics.
if you comment on rescheduling was due to two experiences withaccountants.
where we use the term for which reprogramming the meters were sent to...
finally swap the control panel and irc2620 worked normally.
but the irc 3200 error code and 246-0001.
I think it is wrong to counter (not traded) with any other team.
this pcb (s ram) can be...
if it refers to the PCB shown in the picture, and was also replaced with the power supply.
have the opportunity to review again the teams tomorrow.
perrón(big dog)
oops missed comment, both PCB power supply and fuse andreplace with the same result.
with respect to irc2620 reeplace no more than the boot rom.
shall withdraw the DDR SDRAM. and commentators...
hello from México
have irc3200 operate 1 hour ok, after screen blank, off copier then on, only lite power, panel & touchscreen no lite.I have a irc2680 also has the same fault.
probe cards, boot...